-
_MATLAB
是用matlab进行编写的源代码，是研究生课后习题的作业题。(matlab source)
- 2010-10-04 11:55:57下载
- 积分：1
-
hurst-estimators
8种自相似数据的Hurst指数估计方法，matlab源码，可读性强(hurst estimators)
- 2015-03-26 20:53:07下载
- 积分：1
-
aca_path
利用蚂蚁算法求解最短路径问题，稍作修改既可以用于移动机器人路径规划当中。(Ants use the shortest path algorithm to solve the problem, with some slight modifications can be used in mobile robot path planning among them.)
- 2008-12-17 17:14:45下载
- 积分：1
-
fastICA_data1
信号处理的Fast ICA实现进行快速独立分量分析(Fast ICA signal processing to achieve fast independent component analysis)
- 2013-11-06 14:42:45下载
- 积分：1
-
code
角点检测程序源码，使用的是HARRIS角点提取方法，效果很好。(Corner detection program source code, using extraction methods HARRIS corner, very good.)
- 2007-11-28 22:12:20下载
- 积分：1
-
scatterinwire2
antenna systems continue
- 2010-05-19 03:44:36下载
- 积分：1
-
chap4
.已知某炉温控制系统，要求温度保持在600℃恒定，针对该控制系统有以下控制经验：
（1）若炉温低于600℃，则升压，低的越多升压越高；
（2）若炉温高于600℃，则降压，高得越多降压越低；
（3）若炉温等于600℃，则保持电压不变。
设模糊控制器为一维控制器，输入语言变量为误差，输出为控制电压。输入输出变量的量化等级为7级，取5个模糊集，试设计隶属度函数误差变化划分表，控制电压变化划分表和模糊控制规则表。
(Known for a temperature control system that requires a constant temperature is maintained at 600 ℃, the following control experience for the control system:
(1) If the furnace temperature is below 600 ℃, the step-up, the more the higher the lower the boost
(2) if the furnace temperature is higher than 600 ℃, the blood pressure, high blood pressure, the lower the more
(3) If the furnace temperature is equal to 600 ℃, then keep the voltage constant.
Set of fuzzy controller for one-dimensional controller, input linguistic variables for error, the output control voltage. Input and output variables of quantization levels for seven, take five fuzzy sets, membership function test design error variance divided table, partition table and the control voltage variation fuzzy control rule table.)
- 2015-04-10 21:53:18下载
- 积分：1
-
three_dim_plot
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:56:06下载
- 积分：1
-
tyjzd
计算肿瘤的椭圆紧致度，用于医学图像处理中，用来判别肿瘤的良恶性。(Calculated tumor oval firmness for medical image processing, for discriminating benign and malignant tumors.)
- 2020-07-01 09:40:02下载
- 积分：1
-
BlindSignaSeparationalgorithm
speech processing for signal seperation
- 2010-09-06 02:42:13下载
- 积分：1
