-
Unitary--ESPRIT
新的2维角度估计的高分辨方法。该方法首先建立基于范数约束的最优化问题的目标函数；然后用迭代算法沿均匀面阵接收数据的方位向求最小化目标函数的稀疏解，得到方位、俯仰角耦合的空间角频率，并分离信号；最后对每个分离的信号，沿面阵俯仰向求稀疏解，得到信号的俯仰角，进而求得对应的方位角。(The new high-resolution 2-D angle estimation method. Firstly, the establishment of an objective function optimization problems based on norm constraint then iterative algorithm along with uniform orientation plane array receives data to seek to minimize the objective function is sparse solution, get directions, spatial frequency coupling angle pitch angle, and separated signals Finally for each signal separation along the sparse area array pitch to seek solutions to obtain the pitch angle of the signal, and then obtain the corresponding azimuth.)
- 2014-02-19 13:29:49下载
- 积分：1
-
SPEECH
用matlab实现语音录放，并且画出频域和时域波形。(Using matlab voice recorders, and draw the frequency-domain and time-domain waveform.)
- 2014-06-05 17:47:56下载
- 积分：1
-
oqpskmod
这里有OQPSK的调制源程序代码，用matlab做的，很好，需要的可以在这里下载(There are OQPSK modulation source code, using matlab to do, and very good, needs can be downloaded here)
- 2007-10-24 20:17:21下载
- 积分：1
-
ssnpr
基于Heeb监督的单神经元自适应PID控制器S函数程序(Heeb supervision based on single neuron adaptive PID controller function S procedures)
- 2009-04-23 20:39:04下载
- 积分：1
-
MATLAB_code
real genetic algorithm matlab code
- 2009-05-20 18:17:16下载
- 积分：1
-
CCA
典型相关分析的Matlab实现，实现相关系数的最大(Canonical Correlation Analysis source program using Matlab)
- 2021-03-11 13:29:25下载
- 积分：1
-
MIMOLS
MIMO阵列的最小二乘算法，LS算法。编写并验证可用。(LS for MIMO array。)
- 2015-03-18 21:18:15下载
- 积分：1
-
-wavefront
波前曲扭和幅度变化对阵列测向中相干源分辨的影响(Twisted and curved wavefront amplitude variation to distinguish the impact of coherent source direction finding in an array)
- 2013-12-26 12:54:01下载
- 积分：1
-
My_maxentropy
最大熵复原MATLAB程序，可以直接运行，注释详细，并可与维纳、盲LUCY方法作比较，希望对初学者有一些帮助(Maximum entropy restoration MATLAB program can run, comment in detail, and can and Wiener, blind method for comparison LUCY, I hope there is some help for beginners)
- 2010-06-24 21:04:39下载
- 积分：1
-
Newton
本程序为：用牛顿迭代法求解非线性方程2*(x^3)-4*(x^2)+3x-6=0在1.5附近的根的具体程序。(This program is: The Newton iteration method for solving nonlinear equations 2* (x ^ 3)-4* (x ^ 2)+3 x-6 = 0 near the roots at 1.5 specific procedures.)
- 2010-10-08 21:45:08下载
- 积分：1
