登录
首页 » MultiPlatform » kaiguandianyuan

kaiguandianyuan

于 2012-03-11 发布 文件大小:1860KB
0 151
下载积分: 1 下载次数: 53

代码说明:

  Buck变换器是最常用的变换器,工程上常用的拓扑如正激、半桥、全桥、推挽等也属于Buck族,其中Buck变换器补偿网络设计,是开关电源的重要研究课题,本文将针对基于PI控制方式的4A开关电源进行设计和Multisim的仿真研究。(Buck converter is the most commonly used converter on the topology of the project, such as forward, half bridge, full bridge, push-pull, the Buck family, Buck Converter compensation network design is an important research topic of the switching power supply, this paper4A-based PI control switching power supply design and Multisim simulation study)

文件列表:

buck变换器仿真图.ms10,84725,2011-07-06
电感电流仿真图.ms10,1861479,2011-07-06

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • UWBzihanshu
    超宽带信号(uwb),做超宽带信号分析时必用的程序,希望有所帮助!(UWB signal (uwb), so ultra-wideband signal analysis procedures will be used in the hope that help!)
    2010-07-05 13:14:26下载
    积分:1
  • Burg06
    自己编写的burg算法实现的matlab源程序,希望对大家有用。(I have written burg algorithm of matlab source, and I hope useful.)
    2010-11-04 14:47:00下载
    积分:1
  • junyun_rand_ps_zAxis_4s
    光子筛孔分布的例程,环数相同,用于光子筛成像时使用(Photon sieve distribution routines same ring number, is used for imaging photon sieve)
    2013-10-14 20:04:05下载
    积分:1
  • Power-spectrum-analysis
    这个是基于matlab的关于功率谱问题的相关理论知识以及程序介绍(This is based on the power spectrum matlab problems on the theory of knowledge and procedures described)
    2011-11-09 14:49:34下载
    积分:1
  • engineering-computation
    Clear Brief Introduction to Engineering Computation with MATLAB
    2012-11-07 03:09:13下载
    积分:1
  • EOFcgx
    eof分解用的函数,说明如下:function [EOF,PC,F,diff]=EOFcgx(X) EOF分解。Xm*n 空间数据维数m,n为时间采样点 返回值EOF为空间模态,PC为时间模态。第一空间模态EOF(:,1),第一时间模态PC(1,:) 返回值F为特征值,diff为误差 (eof decomposition function as follows: function [EOF, PC, F, diff] = EOFcgx (X) EOF decomposition. Xm* n spatial dimension m, n is the time of sampling points Returns the value EOF spatial modes, PC is the time modes. The first space modal EOF (:, 1), the first time the modal PC (1, :) Return value F for eigenvalues, diff for error )
    2015-01-12 20:05:30下载
    积分:1
  • 1213
    LDPC码matlab的,演示程序,mpsk(ldpc)
    2010-06-02 11:15:27下载
    积分:1
  • Iron.Man.3.2013.720p.BluRay.x264.YIFY
    of the electrical power system. At the time of transformer energization high current is drawn by the transformer known as the inrush current. This current is nearly ten times more than the full load current of transformer. It produces mechanical stress on transformer and also affects the windings and bushings of the transformer. The large switching transient current affects malfunction of protection system of power system and the different equipments connected to system. So the inrush current should be minimized. There are different methods used to minimize the inrush current such as volt second balance, series compensator, point on wave switching method etc. This paper focuses on point on wave switching method. It also explains the results for inrush current of three phase transformer with and without point on wave switching method. A test is driven on 450 kVA, 500kV/230kV grounded Y/D transformer in MATLAB/SIMLINK environment. It also focuses on
    2014-12-26 23:00:05下载
    积分:1
  • snake
    This program is an implementation of snake algorithm with matlab.
    2010-10-19 20:56:15下载
    积分:1
  • ecg_analysis_2min_3kai
    对心电信号进行滤波处理后,计算RR间隔,进而求得瞬时心率和心率变异系数,通过对RR间隔的变化曲线进行频谱分析,从而求得各个自律神经活动的评价指标(After filter processing is performed on the ECG, the RR interval is calculated, and then seek the instantaneous heart rate and heart rate variability coefficient, spectral analysis through the curves of changes in the RR interval, to thereby obtain the evaluation index for each of the autonomic nervous activity)
    2012-10-10 19:40:24下载
    积分:1
  • 696518资源总数
  • 105885会员总数
  • 31今日下载