-
Matlab_filter
用fdatool设计一个50Hz陷波器，导出系数，编程，对原始信号signal.txt进行滤波。
本程序为Matlab程序。(50Hz with fdatool design a notch filter, export coefficient, programming, filtering the original signal signal.txt.)
- 2010-11-22 17:32:15下载
- 积分：1
-
Project1
C++ 生成画图数据，main函数开启matlab engine，分配存储空间，绘图(C++ calls matlab engine to plot graphics)
- 2014-01-19 00:23:08下载
- 积分：1
-
dierti
这是我在学习过程使用到的一些程序，希望对大家有所帮助!(This is what I used in the learning process some of the procedures, I hope all of you to help!)
- 2009-04-10 22:01:20下载
- 积分：1
-
eee
杨氏双缝干涉
两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2,
满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ,
最后可得公式如下：
，
最后光强I=4I0cos2（Φ/2）。
观察相干光叠加后光强的分布.
(Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)
- 2013-01-03 21:04:13下载
- 积分：1
-
eg1OC
最优控制教程，里面详述了不同最优控制方法的解决方法(Optimal control tutorial)
- 2012-07-12 23:29:35下载
- 积分：1
-
TVAR
基于期望最大化的时变参数建模，时频分辨率高(Based on expectation maximization of time-varying parameter modeling, high time-frequency resolution)
- 2014-09-08 09:50:36下载
- 积分：1
-
Prog_Sliding
sliding mode controller
- 2013-09-05 16:38:12下载
- 积分：1
-
zxecf
一次完成最小二乘法辨识系统程序,可以仿真(A complete system parameter identification program that can emulate)
- 2014-11-20 22:18:43下载
- 积分：1
-
LinearPP
The liear principle analysis code
- 2010-10-20 16:03:53下载
- 积分：1
-
perception
模式识别中，用线性预测分类器实现逻辑与和逻辑或，MATLAB实现(pattern recognition, classification using linear prediction logic device to achieve and logic, or, MATLAB)
- 2007-03-02 18:40:16下载
- 积分：1
