-
matlab-optimization-of-braced-structures4
Matlab Optimization of braced structures
- 2012-11-15 15:56:48下载
- 积分：1
-
semi-manuf-fall2006
Microelectronics Fabrication
- 2010-10-08 08:03:12下载
- 积分：1
-
qiantuihuidai
这个程序是根据前推回代法计算潮流的，算法简单明了。(This program is based on forward and backward substitution method to calculate the trend of the algorithm is simple and clear.)
- 2010-11-16 16:02:28下载
- 积分：1
-
mohu
模糊自适应pid与传统pid对比，有较好的跟踪控制效果(fuzzy control)
- 2011-11-21 15:43:30下载
- 积分：1
-
DOA_MUSIC
该程序很好解决了，将两个矩阵交叉相加的结果取出，直接相加的结果所对应的行省略.
另外一个是DOA估计的程序。(It is good for solving the two matrix for cross adding,and delete the direct adding.)
- 2012-12-02 22:02:17下载
- 积分：1
-
ICEE-574
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:54:09下载
- 积分：1
-
exInfomax-BSS
扩展INFOMAX算法是盲源分离算法中极大似然估计的一种扩展，功能更强大。(The extended INFOMAX algorithm is an extension of the maximum likelihood estimation in the blind source separation algorithm, and the function is more powerful.)
- 2021-04-25 17:08:46下载
- 积分：1
-
kalmanFilter
kalman滤波器一个matlab程序，用于处理语音信号。(a kalman filter matlab program for the treatment of voice signal.)
- 2007-11-16 00:49:40下载
- 积分：1
-
HHT_power-system_power-quality_disturbances-detect
优秀论文及配套源码。Hilbert-Huang变换(HHT)是一种新的非平稳信号处理技术，该方法由经验模态 分解(EMD)与Hilbert谱分析两部分组成。任意的非平稳信号首先经过EMD方法处理后被分解为一系列具有不同特征尺度的数据序列，每一个序列称为一个固有模态函数(IMF)，然后对每个IMF分量进行Hilbert谱分析得到相应分量的Hilbert谱，汇总所有Hilbert谱就得到了原信号的谱图。该方法从本质上讲是对非平稳信号进行平稳化处理，将信号中真实存在的不同尺度波动或趋势逐级分解出来，最终用瞬时频率和能量来表征原信号的频率含量。
本文研究了基于HHT的暂态电能质量扰动检测方法，介绍了HHT的基本原理和利用HHT检测电能质量多扰动信号的实现方法。仿真试验表明该方法可以实时检测扰动的起止时刻，持续时间和扰动幅度，适用于电能质量多扰动的监测和辨识系统。
(Hilbert-Huang Transform(HHT) is a new non-stationary signal processing technology，including the Empirical Mode Decomposition(EMD) and Hilbert spectral analysis．In this method，arbitrary non-stationary signals was divided into a series data sequence with different characteristic scales after the first EMD treatment，each sequence is called an intrinsic mode function(IMF)，and then each IMF component gained corresponding the Hilbert spectrum though Hilbert spectrum analysis，a summary of all Hilbert spectrum assembled to the spectra of the original signal．In essence，this method is a stable processing for non-stationary signal，which decomposed the different fluctuations or trends in the signal in rum，and represented the frequency content of the original signal using the final instantaneous frequency and energy．
This paper study a method to detect power quality disturbances based on the HHT，in which the principle and the realization of the HHT and the realization of power quality disturbance)
- 2021-04-24 10:48:48下载
- 积分：1
-
docs
good for develoment.
latest papers
- 2010-05-10 10:10:49下载
- 积分：1
