登录
首页 » matlab » m33

m33

于 2015-07-02 发布 文件大小:1KB
0 73
下载积分: 1 下载次数: 15

代码说明:

  二维方腔流动流函数涡量法.上边界为移动边界,cavity流动,涡量为负值。(Dimensional square cavity flow stream function vorticity law. On boundaries for the moving boundary, cavity flow, vorticity is negative.)

文件列表:

m33.m,2748,2015-07-01

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SL0MatlabCodeV2
    压缩感知中用SLO重构的典型程序,一种最近才产生的新算法,误差有所降低(Compressed sensing reconstruction using the typical procedure OMP)
    2011-04-27 09:44:56下载
    积分:1
  • yuyindaoxu
    用Matlab以及c语言求语音序列的倒谱 这某段语音信号求FFT、取模、取log、IFFT得到倒谱,并画图。选取一段进行分析,分别对浊音和清音各自求倒谱。(Using Matlab, as well as for c language serial Cepstral voice that voice signal for a certain period of FFT, check mode, check log, IFFT been cepstrum, and drawing. Select a section of the analysis, respectively, and the voiceless to voiced their demand cepstrum.)
    2021-05-24 01:30:02下载
    积分:1
  • ShortDipole
    short dipole antenna input impedance by moment method
    2009-10-18 00:26:22下载
    积分:1
  • a
    说明:  本程序是对语音信号去除噪声。MATLAB编写(This procedure is a speech signal to remove noise. MATLAB prepared)
    2009-06-16 11:23:04下载
    积分:1
  • simulition
    说明:  一阶船舶操纵运动模型动态仿真的研究,是基于matlab的船舶旋回仿真,希望对大家有所帮助。(very good!)
    2020-11-18 21:49:40下载
    积分:1
  • Michelson-interferometer-simulation
    该代码能是针对物理实验光学仿真,实现基于matlab的迈克尔逊干涉仿真。(The code could be for physics experiments optics simulation, matlab-based simulation of a Michelson interferometer.)
    2014-02-01 13:40:39下载
    积分:1
  • lvboqi
    巴特沃斯滤波器,切比雪夫滤波器,椭圆滤波器设计及比较,同样的设计参数指标,在同一张图中比较三种滤波器的幅频响应波形,并用统计图画出各滤波器所需阶数。(Butterworth filter, Chebyshev filter, elliptic filter design, the same design parameter index, with a figure in the comparison of three filter frequency response waveform, and use statistical picture of the desired order of each filter.)
    2013-05-25 16:28:57下载
    积分:1
  • kongjianpinghua
    适用于水下信号分析的空间平滑MUSIC算法源代码,对学习空间谱MUSIC算法的初学者有一定的参考作用
    2009-04-27 08:37:54下载
    积分:1
  • NetCreate
    现有的几个网络拓扑随机发生器,其实很难生成理想的网络拓扑结构,其主要原因在于很难控制节点的疏密和间距。我们提出来的这个改进算法,在随机抛撒节点的时候使用了K均值聚类,由本算法作为网络拓扑发生器,网络节点分布均匀且疏密得当,边的分布也比较均衡(The few existing random network topology generator, is in fact very difficult to generate the desired network topology, the main reason it is difficult to control the node density and spacing. We put forward the improved algorithm, throw in random nodes when using the K-means clustering, by the algorithm as a network topology generator, network nodes and spacing evenly distributed properly, the edge of a more balanced distribution of)
    2008-04-19 09:20:34下载
    积分:1
  • MoM
    describle the use of MoM
    2010-12-24 10:35:45下载
    积分:1
  • 696524资源总数
  • 103938会员总数
  • 55今日下载