-
YTY_GA_Final
To find the largest fitness value and its location
寻找最大适应性及相应的位置！ Population N=50；crossover bits=n/2 (half of bits of an individual) with random locations，mutation bits = 4 种群数 N=50，交换位数= n/2, 即个体位数的一半，且位置随机；
变异位数统一取为4；
Nc=20，28，36，44，individuals for crossover(交换的个数)。 Nm=1，5，10，15， individuals for mutation(变异的个数)。 (To find the largest fitness value and its location to find the location of the maximum adaptability and the corresponding! Population N = 50 crossover bits = n/2 (half of bits of an individual) with random locations, mutation bits = 4 population size N = 50, exchange digits = n/2, ie half of the median individual, and random position variation is taken as unity median 4 Nc = 20,28,36,44, individuals for crossover (exchange number). Nm = 1,5,10,15, individuals for mutation (the number of variations.))
- 2010-12-27 21:23:27下载
- 积分：1
-
clc
用matalb程序来实现求一个连通图的最小生成树(matalb procedures used to achieve a graph for the minimum spanning tree)
- 2006-05-22 11:32:04下载
- 积分：1
-
heritrix_developer_manual
Heritrix官方开发文档，crawler.archive.org/articles，提供了基本的类的开发介绍。((Heritrix official development documents, crawler.archive.org/articles, provides a basic introduction class development.))
- 2013-12-24 16:37:34下载
- 积分：1
-
heijai
采用热核构造权重，小波包分析提取振动信号中的特征频率，利用自然梯度算法。( Thermonuclear using weighting factors Wavelet packet analysis to extract vibration signal characteristic frequency, Use of natural gradient algorithm.)
- 2016-05-12 14:48:43下载
- 积分：1
-
jiajiao
ＭＡＴＬＡＢ仿真Ｖ形振子的相关数据 电流 方向性图 (MATLAB simulation of V-shaped vibrator relevant data current directional map)
- 2008-05-31 21:13:26下载
- 积分：1
-
inverse
this function used to calculate MATRIX INVERSE
- 2012-10-03 22:31:32下载
- 积分：1
-
aBookOfMatlab
一本讲授matlab基本知识的书籍，有很多例子，可以帮助入门的人学习。(A basic knowledge of teaching books matlab, there are many examples that can help people who started to learn.)
- 2010-12-29 17:01:18下载
- 积分：1
-
ICEE-574
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:54:09下载
- 积分：1
-
MIMO_RLS
利用递归最小二乘法对MIMO系统进行参数辨识(identify parameters of MIMO system by RLS)
- 2016-06-06 17:39:04下载
- 积分：1
-
DTMB-detection-of-mode-
介绍了一种可在较短时间内检测到数字电视国标系统工作模式的方法。该方法利用帧头PN序列和PN序列扩展保护部
分的相关特性、循环特性以及0FDM信号部分的周期特性进行判决，可达到很好的检测效果，该方法同时可加入跟踪模块对系统
工作模式的突然改变作出反应。还介绍了两种可以在硬件资源和性能上进行折中的检测方法(Describes a method can be detected in a relatively short period of time to a digital television GB system working mode. The method utilizes the correlation characteristics of the the header PN sequence and the PN sequence extension protective portion, the cycle characteristics of the cycle the characteristics and 0FDM signal portion judgment can achieve good detection results, the method at the same time tracking module may be added to the system working mode sudden change the response. Also describes two hardware resources and performance compromise detection method)
- 2013-01-04 10:36:24下载
- 积分：1
