登录
首页 » Objective-C » Lattice

Lattice

于 2015-08-04 发布 文件大小:761KB
0 206
下载积分: 1 下载次数: 4

代码说明:

  用138,595控制的点阵,附带两个不同控制方式的源程序以及电路连接图,(With 138,595 dot control, with two different control modes of the source and a circuit connection diagram,)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • TFT_dis_sin
    以前电子竞赛时写的M3 ARM控制TFT液晶显示正弦波波形可以连贯的左移,没有闪烁感,我还写了一个也是正弦波左移,只不过有一点闪烁,我也上传了,你们需要可以找一下!(Writing contest before the electronic control M3 ARM TFT LCD sinusoidal waveforms can be coherent left, no flashes, I also wrote a sine wave is left, just a little flicker, I also uploaded, you need to be able to Get it!)
    2015-09-06 17:18:50下载
    积分:1
  • MSP430FR57xx_01
    MSP430FR57x Demo - Toggle P1.0 using software Description: Toggle P1.0 using software. ACLK = n/a, MCLK = SMCLK = TACLK = default DCO = ~625 KHz(MSP430FR57x Demo- Toggle P1.0 using software Description: Toggle P1.0 using software. ACLK = n/a, MCLK = SMCLK = TACLK = default DCO = ~625 KHz)
    2011-10-07 15:03:56下载
    积分:1
  • boot
    BOOT引导IAP应用演示程序-目标MCU:MEGA8 晶振:外部(EXT) 8MHZ (BOOT boot IAP application demo program- Target MCU: MEGA8 Crystal: External (EXT) 8MHZ)
    2013-05-31 18:41:08下载
    积分:1
  • code
    基于51单片机的信号发生器 四种波形显示 有级调频(Based on 51 single-chip signal generator)
    2013-09-02 09:33:34下载
    积分:1
  • AT89S52键盘程序 03Key51
    AT89S52键盘程序,这是一个变频器的键盘驱动程序,简单,可靠,芯片为51单片机(one simple progrem for 51,if you like ,you can use it freely.)
    2020-06-28 13:20:02下载
    积分:1
  • sprc675
    TI 官方光伏逆变器学习资料。一个完整的110V纯正弦波输出逆变器学习资料,软硬件都有。(TI Inverter learning resource.)
    2016-01-13 15:11:50下载
    积分:1
  • IPHONE4
    Simple app that communicates with the iPhone/iPod/iPad serial port for debugging/hobbyst purpose.
    2014-03-14 09:15:49下载
    积分:1
  • shumaguan
    51单片机动态数码管显示开发程序,对单片机初学者有一定的参考指导作用,欢迎下载参考研究,谢谢!(51 single-chip dynamic digital display development program, microcontroller beginners have a certain role in guiding, are welcome to download the reference study, thank you!)
    2012-04-20 16:37:29下载
    积分:1
  • www.mcufz.com
    网络控制单片机proteus仿真 利用网络控制单片机的LED、LCD,我只是整理了一下,方便大家学习,版权归原作者,网页也麻烦站长做好了,有一个上位机,点击自动运行一段程序和打开www.mcufz.com/tcp.htm,之后会自动关闭,有的杀毒软件会报是病毒,放心使用。 开始要安装一个WinPcap软件,不安装它不能仿真,然后运行仿真文件,过一会可以看到LCD显示出了IP地址50。1。1。1 (Proteus simulation network control the use of single-chip microcontroller network control LED, LCD, I am just finishing a bit, to facilitate learning, belongs to original author, the website also do a good job of head trouble, there is a host computer, click Automatic operation for some procedures and open www.mcufz.com/tcp.htm, will automatically shut down after some anti-virus software will be reported to viruses, ease of use. WinPcap started to install a software, do not install it can not simulation, and then run the simulation documents LCD moment we can see the IP addresses shows that 50. 1. 1.1)
    2009-05-29 05:29:37下载
    积分:1
  • M3658_J1939
    J1939 protocol description
    2012-11-10 17:35:38下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载