登录
首页 » Visual C++ » 11

11

于 2014-05-27 发布 文件大小:6KB
0 316
下载积分: 1 下载次数: 0

代码说明:

说明:  利用定时/计数器T0从P1.0输出周期为1s的方波,让发光二极管以1HZ闪烁,设晶振频率为12MHz(The use of timer/counter T0 from P1.0 output cycle square wave 1s, so that the light-emitting diodes 1HZ blinking, set the crystal frequency is 12MHz)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • LCD35
    不错的拓普微3.5寸LCD显示屏驱动代码,可以参考(Good TOPWAY 3.5-inch LCD display driver code, you can refer to it)
    2013-09-24 12:54:35下载
    积分:1
  • zhongjile
    通过51单片机设计一个电子时钟,精确到秒,可以通过按键调节时间(By 51 microcontroller design an electronic clock, accurate to seconds, you can adjust the time by pressing a button)
    2013-11-14 09:56:13下载
    积分:1
  • 500w_PIC_Modified_Sine_Wave_Inverter
    pic modified sine wave inverter circiut
    2013-12-24 07:42:05下载
    积分:1
  • DS18B20A
    相信大大家都用过DS18B20A,我自己也用手写了个玩玩(Believe that we all used DS18B20A, I have to play with a hand-written)
    2009-07-17 08:39:25下载
    积分:1
  • HW-GMS-Project20140513
    BlueCore4 Datasheet BC417143 ·APF有源滤波控制器程序,因为改代码 ·利用51单片机实现DS1302的驱动,以C ·利用STM8L实现诺基亚5110液晶的驱动 ·盛群单片机指令集:简体中文,PDF格 ·SHT11 程序,I2C总线方式。写I2C时 ·7寸彩屏 STM32的固件库3.5 FSMC驱动 ·一种伺服电机的PID控制算法,可以完 ·基于Atmega16单片机的机器人行走、 ·51单片机驱动2.6英寸触摸液晶屏幕, ·stm32 pwm 固件库 大连理工大学 信 ·无线传感网络基础 wireless sensor ·LPC11u14芯片的系统时钟驱动
    2020-11-24 16:09:33下载
    积分:1
  • AD_SOFT
    用华北工控pc104嵌入式主板开发的ad数据采集系统应用于传感器采集处理( 您是不是要找: 用华北工控pc 104嵌入式主板开发的ad数据采集系统应用于传感器采集处理 NORCO pc104 with embedded motherboards developed ad data acquisition system applied to the sensor acquisition and processing)
    2014-12-30 12:23:21下载
    积分:1
  • ASD24B201303
    Delta servo drive a new generation of hardware ASDA-B2 manual programming is an electrical engineer hardware reference manual,
    2014-02-24 15:14:34下载
    积分:1
  • 1.8TFT
    实现1.8寸tft彩屏的驱动,能够显示字符,汉字,以及图片。(Achieve 1.8-inch tft color screen driver, can display characters, characters, and images.)
    2020-06-28 18:40:02下载
    积分:1
  • MySlide
    自绘的滑块控件。显示进度等信息。。汽车仪表(Since the painting of the slider control. Display progress and other information. . Auto Meter)
    2014-01-25 13:27:32下载
    积分:1
  • CT
    说明:  双路输出控制器”具有信号输出时间设定、 输出信号占空比调整、 当前输出通道及时 间显示、系统工作参数存储、串口通讯及 LED 指示等功能。 “双路输出控制器”通过串口完 成信号输出时间设定功能;通过 EEPROM 完成系统工作参数存储功能;通过按键完成输出通 道切换、 输出信号占空比调整及停止信号输出功能; 系统硬件电路主要由 MCU 控制单元、独 立按键、 LCD 显示单元、 串口通讯单元、 EEPROM 数据存储单元和 LED 指示单元组成(Dual output controller has the signal output time setting, adjust the duty cycle of the output signal, the current output channel in time Between display, system operating parameters are stored, serial communications and LED indicator. Dual Output Controller through serial END A signal output time setting function complete system operating parameters via EEPROM memory function complete output pass through the key Channel switching, adjust the duty cycle of the output signal and the stop signal output function the system hardware circuit is mainly controlled by the MCU unit, alone Li buttons, LCD display unit, serial communication unit, EEPROM data storage unit and LED indication units)
    2015-03-10 20:14:34下载
    积分:1
  • 696518资源总数
  • 106245会员总数
  • 18今日下载