登录
首页 » C# » traffic-light

traffic-light

于 2015-09-13 发布 文件大小:229KB
0 137
下载积分: 1 下载次数: 3

代码说明:

  文件包括交通灯的程序代码,实物图的照片,和功能原理图,可以帮助同学们做成一个完整的实物,包括硬件连接和软件程序调试(Documents including traffic lights program code, the real figure photos, schematic diagram and function, can help the students to make a complete physical, including the hardware connection and software program debugging)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 111
    用数码管显示电压,发送到串口,然后有高低电压报警,只有部分代码(Display voltage with digital tube, send it to serial port, then alarm with high and low voltage, only part of the code)
    2020-06-22 14:40:01下载
    积分:1
  • R5F100LE-USART-TX-and-RX
    基于瑞萨单片机RL78的串口队列操作程序。利用串口中断和瑞萨的串口接受完成函数,实现瑞萨的串口中断队列接受功能。(Renesas RL78 microcontroller based serial queue procedures. Use serial port interrupt and Renesas serial reception complete function, enabling Renesas to accept the serial interrupt queue function.)
    2015-09-03 02:00:08下载
    积分:1
  • inverter_SIMCAD_simulate
    逆变器以及两个逆变器并联在simcad仿真环境下的实现(inverter and two inverters in parallel simulation environment simcad Implementation)
    2007-06-21 16:57:25下载
    积分:1
  • add-leds-speed
    C8051f120的AD程序,调节电位器控制八个led灯的亮灭和闪烁频率(C8051f120 the AD process, adjust potentiometer control eight led lights out and flicker frequency)
    2013-07-23 20:30:44下载
    积分:1
  • icread
    说明:  IC卡读写程序,内有终端PCB及原理图.爱好者可以看一下.也许会有所帮助.(IC card reading and writing process, there are terminal PCB and schematic. Lovers can look at. Maybe be helpful.)
    2008-10-10 16:40:45下载
    积分:1
  • STC15F104W模拟串口实现自动下载
    说明:  STC15F104W模拟串口实现自动下载(Stc15f104w analog serial port realizes automatic download)
    2020-04-27 14:38:58下载
    积分:1
  • LED
    复杂的数码管动态显示和流水灯,分别用两个定时器做中断(Complex digital dynamic display and light water, respectively, two timers interrupt)
    2012-10-16 23:49:57下载
    积分:1
  • DSPFiltersComplete
    实现小波算法,FFT以及滤波器,以及许多数学计算常用函数(this file complete wave,fft,filter and math function)
    2020-06-19 22:40:02下载
    积分:1
  • c51control
    说明:  适用51单片机的程序,可以进行气压测量进行自动控制继电器(51 MCU application procedures, pressure measurements can control relays)
    2021-04-22 15:38:49下载
    积分:1
  • IIC实验
    开机的时候先检测 24C02 是否存在,然后在主循环里面检测两个按键,其中 1 个按键(KEY1) 用来执行写入 24C02 的操作,另外一个按键(KEY0) 用来执行读出操作,在 TFTLCD 模块上显示相关信息。同时用 DS0 提示程序正在运行。(When booting, it first detects the existence of 24C02, and then detects two keys in the main loop. One key (KEY1) is used to write 24C02, and the other key (KEY0) is used to read out, displaying relevant information on the TFTLCD module. At the same time, the DS0 prompt program is running.)
    2020-06-17 01:20:01下载
    积分:1
  • 696516资源总数
  • 106442会员总数
  • 11今日下载