-
sins-matlab
捷联惯导系统的matlab程序源代码，包含输出代码，非常好用(The SINS matlab program source code, including the output code, it is very easy to use)
- 2012-04-01 11:42:07下载
- 积分：1
-
channel_coeff
mimo-ofdm系统中产生相关mimo衰落信道(produce relevant mimo mimo-ofdm fading channel system)
- 2013-12-04 17:15:22下载
- 积分：1
-
For-ncomplex-indllSt.rar
模型是进行控制与稳定性分析的基础，可以服务于仿真、系统行为分析、系
统内在机理分析、控制、预测、监督与故障诊断等目的。因此，建立系统的模型
已成为许多科学研究与工程实施的首要问题。(Model is the basis for control and stability analysis, can serve simulation, system behavior analysis, the internal mechanism of the system analysis, control, forecasting, monitoring and troubleshooting purposes. Therefore, the establishment of the system model has been implemented for many scientific and engineering the most important issue.)
- 2013-10-17 09:54:51下载
- 积分：1
-
dynam
dynamics analysis of SC robot
- 2015-01-28 17:39:17下载
- 积分：1
-
two_level_FOC
针对异步电动机转子磁链定向的矢量控制系统，逆变部分采用的三电平拓扑结构，算法是采用的传统的SVPWM调制方法。(For the vector control system of induction motor rotor flux orientation, the three level topology is adopted in the inverter, and the algorithm is the traditional SVPWM modulation method.)
- 2016-12-29 19:46:49下载
- 积分：1
-
MATLAB-Recipes-for-Earth-Sciences
MATLAB Recipes for Earth Sciences
- 2010-08-28 00:43:48下载
- 积分：1
-
deconvwnr
deconvwnr.rar 很有用的一个程序,做维纳滤波的可以(deconvwnr.rar a useful procedure to do the Wiener filter can be)
- 2008-05-08 21:13:15下载
- 积分：1
-
Content-Based-Image-Retrieval
content based image retrieval in matlab..gud work
- 2011-05-03 20:51:17下载
- 积分：1
-
gold
这是一个gold序列代码 本人是搞扩频码的对这方面比较有研究 (gold sequence)
- 2013-04-02 21:32:27下载
- 积分：1
-
项目4
说明： 任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。
要求：
1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。
2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。
3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify.
Requirement:
1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km.
2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm.
3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
- 2019-05-13 09:39:41下载
- 积分：1
