-
MATLAB_programming_parsing_tutorial
MATLAB程序设计语法解析教程MATLAB programming parsing tutorial(MATLAB programming parsing Tutorial MATLAB programming parsing tutorial)
- 2010-08-02 12:15:56下载
- 积分：1
-
zuixiaoercheng
用matlab编写的一个程序,实现系统辨识中的最小二乘递推算法,有运行结果和图形.(Matlab prepared using a procedure to realize system identification in the recursive least squares algorithm, has run the results and graphics.)
- 2008-05-21 16:08:24下载
- 积分：1
-
zixiangguan
说明： 一时间离散序列的自相关函数计算与DFT得出的功率谱(For a discrete sequence calculated the autocorrelation function of the power spectrum obtained with the DFT)
- 2011-03-10 09:06:42下载
- 积分：1
-
THE_FAST_HANDOVER_RESEARCH_of_wimax_network
说明： 本文正是在研究WIMAX/802.16e协议和FMIPv6协议的基础之
上，提出了基于FMIPv6的WIMAX网络快速切换机制，该方案采用跨
层切换的思想，MAC层联合网络层同时进行切换，在链路尚未断开
之前即完成新转交地址(NCOA)获取等功能，从而加快了切换进程，
减小了切换时延和切换时的丢包率。在提出本切换机制的基础上，本
文在NSZ仿真平台上对所提出的切换方案做了系统性的性能仿真，通
过仿真结果验证了方案的可行性和优越性。
( In this paper, IEEE802.16e standard is described at first. Then an
introduction for the basic knowledge and research in MIPv6 and FMIPv6
protocol is given. A fast handover scheme of WiMAX network which
based on FMIPv6 protocol is suggested, which implements the fast
handover at IP layer associating with MAC layer at the same time.
scheme minimizes handover latency by predicting and preparing
This
the
impending handover in advance. Finally, simulation are carried out to
evaluate the performance of this fast handover scheme. The result of the
simulation shows that the fast handover scheme has good performance.
)
- 2010-04-28 09:22:20下载
- 积分：1
-
db4
用DB4小波进行多尺度分解，分解级数为6层的降噪程序(DB4 Wavelets )
- 2010-06-03 22:35:47下载
- 积分：1
-
durbin
用levionson_durbin算法求解lpc winner滤波器的最优系数并求预测误差(Levionson_durbin algorithm using lpc winner of the optimal filter coefficients and prediction error for)
- 2007-10-14 08:43:00下载
- 积分：1
-
shapes_2
detect shapes using properties of region props
- 2011-01-23 04:53:32下载
- 积分：1
-
matlab
A matlab book which writing in Chinese.
- 2011-06-17 15:51:40下载
- 积分：1
-
control_input
This script will setup the nonlinear simulation (UAV_NL.mdl) and call
trim and linearization routines. Select the desired aircraft here in this
script, via the "UAV_config()" function call.
- 2013-07-20 15:58:32下载
- 积分：1
-
LTE-SAE-Model-and-its-Implementation-in-NS-2
LTE/SAE Model and its Implementation in NS 2
- 2014-10-28 20:04:09下载
- 积分：1
