登录
首页 » matlab » Myfloyd

Myfloyd

于 2018-12-27 发布 文件大小:1KB
0 194
下载积分: 1 下载次数: 17

代码说明:

  计算两组数据的皮尔逊相关系数,取值位于-1到1之间,绝对值越大,线性相关性越好。(Calculate the Pearson correlation coefficient between the two sets of data)

文件列表:

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MIMO-OFDMChannelEstimationBasedonCombPilot
    mimo-ofdm系统基于梳状导频的信道估计,使用最小二乘法,线性内插。(mimo- ofdm system based on comb-Pilot channel estimation, the use of least squares linear interpolation.)
    2007-06-13 21:28:51下载
    积分:1
  • GPS-positioning
    C# 编写的GPS定位程序,简单易懂,适于初学者(GPS pisitioning program using C# language)
    2014-10-07 10:46:35下载
    积分:1
  • RBF神经网络控制设计Matlab仿真
    说明:  RBF神经网络控制设计Matlab仿真程序(ATLAB Simulation Program for RBF Neural Network Control Design)
    2019-05-25 16:19:16下载
    积分:1
  • LFM
    说明:  用MATLAB产生线性跳频信号,中心频率和带宽可调(Using MATLAB to generate linear frequency hopping signal with adjustable center frequency and bandwidth)
    2020-08-27 10:08:13下载
    积分:1
  • bpskandqpskandmsk
    说明:  matlab的bpsk,qpsk,msk,qam打包下载,不是自带的程序函数。按照通信框图做的程序(MATLAB,bpsk,qpsk,msk,qam)
    2010-04-07 22:44:41下载
    积分:1
  • BPSKMRC
    最大比合并(MRC)的分集合并程序;调制方式BPSK;瑞利信道(The diversity merging program of the maximum ratio combination (MRC); modulation mode BPSK; Rayleigh channel)
    2020-11-13 17:29:42下载
    积分:1
  • MATLAB_serial
    matlab串口通信,在MATLAB环境下编程实现串口接收数据(matlab serial communication, in the MATLAB programming environment Serial receive data)
    2020-10-07 13:37:38下载
    积分:1
  • evenChannelize
    数字信道化器的模拟程序,当输入信道个数为偶数时,子信道的提取过程模拟(Digital channel of device simulation program, when the input channel number is an even number, the channel Extraction Process Simulation)
    2008-04-14 15:06:10下载
    积分:1
  • apriori
    关联规则数据挖掘的apriori算法MATLAB程序。。(The apriori association rule data mining algorithm for MATLAB programs. .)
    2009-09-09 15:01:34下载
    积分:1
  • PCM
    在实际的调谐解调电路中,采用的是非相干载波解调,本振信号与发射端的载波信号存在频率偏差和相位抖动,因而解调出来的模拟I、Q基带信号是带有载波误差的信号。这样的模拟基带信号即使采用定时准确的时钟进行取样判决,得到的数字信号也不是原来发射端的调制信号,误差的积累将导致抽样判决后的误码率增大,因此数字QPSK解调电路要对载波误差进行补偿,减少非相干载波解调带来的影响。(In the actual tuning and demodulating circuit, non-coherent carrier demodulation is adopted, and the frequency deviation and phase jitter of the local oscillator signal and the carrier signal of the transmitting end are present, and thus the demodulated analog I and Q baseband signals are signals with carrier error.)
    2019-01-30 20:16:08下载
    积分:1
  • 696518资源总数
  • 105562会员总数
  • 1今日下载