登录
首页 » matlab » Iterarive Deconv

Iterarive Deconv

于 2017-09-06 发布 文件大小:1KB
0 196
下载积分: 1 下载次数: 11

代码说明:

  matlab实现信号迭代解卷积功能。其中包含了三个文件:1.iter_Deconv,迭代解卷积子函数;2.receiver_H,例子中接收线圈系统函数生成子函数;3.测试迭代解卷积的测试函数。(matlab to achieve signal iteration deconvolution function. Which contains three files: 1.iter_Deconv, iteration deconvolution of the cumulative sub-function; 2.receiver_H, in the case of receiving the coil system function to generate sub-functions; 3. Test iteration deconvolution of the test function.)

文件列表:

Iter_Deconv.m
Receiver_H.m
test_Iter_Deconv.m

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • GABP
    基于遗传算法BP网络预测,代码没有使用遗传工具箱,而是根据遗传算法理论进行编程,有助于理解遗传算法原理(BP network prediction based on genetic algorithm, the code does not use genetic toolbox, but according to the theory of programming genetic algorithms, help to understand the principles of genetic algorithms)
    2010-10-03 17:57:06下载
    积分:1
  • isomap
    In statistics, Isomap is one of several widely used low-dimensional embedding methods, where geodesic distances on a weighted graph are incorporated with the classical scaling (metric multidimensional scaling). Isomap is used for computing a quasi-isometric, low-dimensional embedding of a set of high-dimensional data points. The algorithm provides a simple method for estimating the intrinsic geometry of a data manifold based on a rough estimate of each data point’s neighbors on the manifold. Isomap is highly efficient and generally applicable to a broad range of data sources and dimensionalities.
    2021-04-11 22:18:57下载
    积分:1
  • matlab-preprocessor
    说明:  matlab预处理程序,具体是杨氏干涉下条纹图像的预处理和算法的程序(matlab pretreatment procedures, specifically under the Young' s interference fringes image pre-processing procedures and algorithms)
    2011-04-10 16:19:11下载
    积分:1
  • Closeness_Centrality
    这是一个计算复杂网络参数closeness centrality 的程序,已调试(this program is used to caltulate closeness centrality)
    2012-05-16 19:47:21下载
    积分:1
  • TV_inpainting123
    MATLAB MEANSHIFT 图像 处理 代码(The MATLAB MEANSHIFT image processing code)
    2013-03-26 22:43:26下载
    积分:1
  • canny
    this is the code for canny edge detection of image using matlab.
    2014-12-04 01:55:48下载
    积分:1
  • top110
    拓扑优化程序,添加两种新的Heaviside敏度过滤方法。(Topology optimization program, adding two new Heaviside sensitivity filters.)
    2014-12-04 18:28:01下载
    积分:1
  • Untitled2
    ann The models used in MPC are generally intended to represent the behavior of complex dynamical systems. The additional complexity of the MPC control algorithm is not generally needed to provide adequate control of simple systems, which are often controlled well by generic PID controllers. Common dynamic characteristics that are difficult for PID controllers include large time delays and high-order dynamics.
    2013-04-23 12:47:11下载
    积分:1
  • bilateral
    BILATERAL FILTER GUI
    2013-12-23 11:16:31下载
    积分:1
  • ZigBeeIEEE
    The implementation was built on Matlab/Simulink using fundamental components in Simulink to demonstrate how reliably complex modulation schemes can be built, cost effectively and efficiently [5]. The design of ZigBee transmitter using MSK modulation is shown in the Figure 1. Here we map input data bits to 8-chip PN sequences to be transmitted and results in a chip rate of two mega chips per second. After that, resultant chip sequence is send to the serial to parallel converter. It is used here to separate the odd and even bit indexed chips. Following this bipolar data formatting is performed and signal modulated with a 2.4 GHz carrier on the In Phase and QuadraturePhase data stream and adds it to get the required transmitter output signal.
    2014-09-23 20:56:58下载
    积分:1
  • 696518资源总数
  • 106148会员总数
  • 10今日下载