-
Target tracking
先对线性调频信号的压缩，然后设计了雷达对目标跟踪的源程序。(Firstly, the linear FM signal is compressed, then the source program of radar target tracking is designed.)
- 2020-07-26 22:48:41下载
- 积分：1
-
bug2algorithm
说明： bug 2 algorithm to avoid obstacles (code in matlab)
- 2020-03-28 08:13:41下载
- 积分：1
-
spwm-based
说明： 对电机进行基于spwm的变频调速系统，来实现对异步交流电动机的转速调整与三相电流调整(SPWM-based variable frequency speed regulation system for motor)
- 2019-04-29 14:27:57下载
- 积分：1
-
chaos toolbox
说明： 混沌工具箱，能很好的学习和了解混沌，包括绘制吸引子、分岔图、lyapunov指数等(Chaos toolbox can learn and understand chaos well, including drawing attractors, bifurcation graphs, Lyapunov exponents, etc.)
- 2020-10-30 10:29:56下载
- 积分：1
-
PStwoboost
模拟局部阴影下用干扰观测法实现光伏最大功率点跟踪，结果表明能较好实现最大电压的跟踪(Photovoltaic maximum power point tracking using interference observation method)
- 2018-06-10 20:53:55下载
- 积分：1
-
trans_time
各种时间之间的转换，包括：
将GPS周和周内秒转换到公历时间，
由公历日期和GPS周内秒计算公历时间，
将公历GPS时间转换到GPS周和周内秒，
将简化儒略日转换到公历时间，
将公历时间转换到简化儒略日，
从儒略日计算公历时间，
将公历时间转换到儒略日等。(The conversion between various times, including:
Conversion of GPS weeks and weeks to the calendar time,
The calendar time is calculated from the date of the calendar and the seconds within GPS weeks.
The GPS time of the calendar is converted to GPS weeks and within seconds,
Julian day will simplify the conversion to the calendar time,
The Gregorian calendar time to simplify the Julian day,
Calculate the Gregorian calendar time from Julian day,
Convert calendar time to Julian day.)
- 2020-09-16 09:47:57下载
- 积分：1
-
DSP
实现对地震信号 的频谱分析，达到滤波、去噪、提高分辨率等的作用(To realize the spectrum analysis of seismic signals, to achieve the function of filtering, denoising and improving resolution.)
- 2018-05-03 11:14:37下载
- 积分：1
-
HP DMI Tool
修复惠普笔记本升级bios导致的product information not valid(hp to fix product information not valid_hp notebook)
- 2020-11-13 09:49:43下载
- 积分：1
-
bessel
使用白塞尔方法进行大地主题解算，正算由大地线和大地方位角计算经纬度，反算有经纬度计算大地线长度和大地方位角(Using the white Searl method to solve the geodetic problem, we calculate the longitude and latitude by the geodesic and the earth azimuth, and calculate the geodesic length and the large local angle by calculating the longitude and latitude)
- 2021-03-09 14:59:28下载
- 积分：1
-
三极管放大电路设计
说明： 三极管放大实验电路，包括固定偏置/分压偏置，需要根据一些参数确定所选用的电阻值，使得三极管工作在放大状态。本程序将电路设计设计成GUI模式，界面上只需要输入电路设计所需参数，根据相关理论推导，给出相关参数的理论值（放大倍数、输入电阻、输出电阻等），指导实验电路搭建。软件搭建在matlab gui上，方便使用
若干参数说明
beta：三极管放大倍数
Ic：集电极电流
Uce：期望CE间电压
UeCof：Re电阻上点电压与Ucc电压比值，一般0.1-0.2
IbCof：Ib上电流与流过Rb1、Rb2电流的比值，一般0.1
ShuntCe：是否有旁路电容(The experiment circuit of triode amplification, including fixed bias / partial voltage bias, needs to determine the selected resistance value according to some parameters to make the triode work in the amplification state. In this program, the circuit design is designed into GUI mode. Only the parameters needed for circuit design are needed on the interface. According to the relevant theoretical derivation, the theoretical values of the relevant parameters (magnification, input resistance, output resistance, etc.) are given to guide the construction of experimental circuit. The software is built on Matlab GUI, easy to use)
- 2020-04-29 15:11:59下载
- 积分：1
