-
MGDE
阵列信号处理中改进型的盖氏圆信源数估计详细程序(The number of the Gerschgorin source array signal processing, improved estimate detailed procedures)
- 2020-07-03 09:20:01下载
- 积分:1
-
CWduopule
CW脉冲信号的仿真,加多普勒延时后的频谱图(CW pulse signal simulation, Jiaduopule spectrum after delay)
- 2015-05-29 17:05:30下载
- 积分:1
-
jpg2000
matlab code for jpeg2000 compression
- 2010-11-14 20:37:22下载
- 积分:1
-
PRN19
伪随机序列发生及检测程序,适用于卫星通信(Pseudo-random sequence and testing procedures applicable to satellite communications)
- 2010-12-31 16:57:44下载
- 积分:1
-
signal_to_noise_C5510_C6713
application karaoke on dsk6713
- 2011-07-27 22:26:47下载
- 积分:1
-
ejdlbshuangpid
二级倒立摆的双pid控制,由simulink和m函数组成(Pid double inverted pendulum control)
- 2021-03-09 16:09:27下载
- 积分:1
-
Diffusion-k-tensor-Estimation
Diffusion k-tensor Estimation from Q-ball imaging using discretized principal axes
- 2013-11-16 10:14:44下载
- 积分:1
-
grayrelationanalysis
实现灰色关联分析的简单有效的matlab程序,运用熵权法求各指标的权重(Gray correlation analysis to achieve a simple and effective matlab program, using entropy method the weights of each index)
- 2021-02-06 09:39:56下载
- 积分:1
-
Multi_link_sim_v2
Routing of packets has been the primary method by which data have been transmitted across packet networks, such as the Internet. When multiple users are interested in the same data the same source, multicast routing is typically used. However, routing alone is not sufficient to achieve the multicast capacity of a network.
Ahlswede at [1] showed that using network coding that requires intermediate nodes to encode incoming data a multicast capacity equal to the minimum of the min-cut capacities of all the receivers can be achieved.
This multicast capacity cannot be achieved using only routing (with or without replication). There has been a lot work going on to use network coding for multicast in satellite systems.
- 2014-10-02 03:58:24下载
- 积分:1
-
ip_05_05
在不同信噪比条件下,对于不同调制方式所产生的误码率曲线!(Signal to noise ratio in different conditions, for different modulation generated BER curves!)
- 2007-12-05 10:11:10下载
- 积分:1