-
PowerControlinWireles
本文提出一种联合盲自适应梯度算法的功率控制算法，该算法同时对功率向量和接收滤波器权向量进行迭代更新。仿真结果表明，采用本文提出
的功率控制算法， 在系统内用户发射总功率一定的条件下， 可以获得更高的用户信干比和更大的系统容量。(Throughout the monograph, we highlight the use of mathematical
language and tools in the study of power control, including optimiza-
tion theory, control theory, game theory, and linear algebra. Practical
implementations of some of the algorithms in operational networks are
discussed in the concluding chapter. As illustrated by the open prob-
lems presented at the end of most chapters, in the area of power control
in cellular networks, there are still many under-explored directions and
unresolved issues that remain theoretically challenging and practically
important.)
- 2011-01-10 15:35:21下载
- 积分：1
-
431
工作流系统模型的性能等价分析
讨论了基于随机Petri网的工作流系统的顺序、并行、选择、循环4种基本模型,并详细推导了这4种基本模型的性能等价公式.最后通过现实中的一个工作流实例来说明如何建立相应的随机Petri网模型,以及如何利用这些性能等价公式来计算工作流的性能参数.给出了定量分析工作流系统性能的通用方法,通过用这些等价公式不仅可以对复杂的系统进行性能等价化简,而且还可以得到性能参数的乘积解.(Workflow Performance Equivalent points)
- 2010-05-19 09:59:42下载
- 积分：1
-
PSO-matlab-code
粒子群算法的matlab源代码，偶尔搜到的，不知道质量咋样(PSO algorithm matlab source code, and occasionally to search, do not know the quality of Zeyang)
- 2011-05-01 23:54:10下载
- 积分：1
-
63535310S4M
本程序先生成一个“Blocks”信号，然后加上高斯白噪声，再用 db3 小波进行分解，(The Mr. Cheng Xu as a " Blocks" signal, and then add white Gaussian noise, and then ' db3' wavelet decomposed)
- 2010-06-01 23:26:26下载
- 积分：1
-
ag1
用 MATLAB 编写的 免疫算法源程序
比较实用。希望对大家有所帮助。算法很好。(using MATLAB immune algorithm source more practical. We want to help. Algorithm good.)
- 2007-06-04 21:50:28下载
- 积分：1
-
matlab
精通MATLAB优化计算第六到第十四章的源代码文件(Proficient in MATLAB optimization calculation to Chapter 14 of the source code file)
- 2012-11-20 15:38:09下载
- 积分：1
-
kelman-ar
在matlab中对时间序列进行AR建模后采用卡尔曼滤波对比预测和实际的差别。应用于嵌入式实时信号处理(Using the difference between the predicted and actual comparison of the Kalman filter AR modeling of time series.)
- 2021-01-21 17:28:48下载
- 积分：1
-
dfa
支持向量机的matlab代码，根据自己需要修改即可(Support vector machine matlab code can be modified according to their needs)
- 2010-07-04 10:42:25下载
- 积分：1
-
adaptive
interpolation, decimation , LMS & RLS using in Matlab Simulink
- 2010-07-22 16:29:16下载
- 积分：1
-
Link-a-System-Level-OFDM-Simulator
针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.
To start with, go into the folder sys_link_simu, and excute the following commond from matlab:
sys_link_simu_func(a,b)
where a is the link ada)
- 2011-08-09 11:00:53下载
- 积分：1
