-
LMD(matlab)-00
原始lmd算法，效果很不好，不知道程序哪里写错,不太能运行，自己做修改，但是上面的算法比较明确(The original LMD algorithm, the effect is very bad, I don t know where the program is misspelled,but it really can not run.If you want run it,just change a little.Actally the algorithm is clear.)
- 2012-03-25 15:20:33下载
- 积分：1
-
ask
自己编程产生一种二进制调制信号，为数字调制信号的识别做准备。(Their programming to produce a binary modulation signal, the recognition of digital modulation signals in preparation.)
- 2010-05-11 12:23:08下载
- 积分：1
-
GoldSequece
gold序列的matlab仿真，生成gold序列，对于扩频跳频通信系统非常有用的好代码，直接用即可。(matlab gold sequence of simulation, generate gold sequence for frequency hopping spread spectrum communication system is very useful for good code can be directly used.)
- 2015-03-28 15:17:25下载
- 积分：1
-
PMSM_SMVC
永磁同步电机速度环滑模控制 自己研发的可供借鉴(Permanent magnet synchronous motor speed loop sliding mode control； to draw on their own research and development)
- 2012-11-21 13:49:08下载
- 积分：1
-
MatLab_programing
MatLab编程中文版.rar,很经典的国外MATLAB编程书籍，该书籍为翻译后的中文版本。(good resource of studying matlab。)
- 2010-10-29 20:31:43下载
- 积分：1
-
FSKtiaozhi
FSK数字调制simulink仿真，很好的资料，希望对大家有帮助(FSK digital modulation simulink simulation, very good information, we hope to help)
- 2020-12-17 10:59:11下载
- 积分：1
-
04041115_2_bpsk
说明： bpsk分布，awgn,瑞丽衰落信道，调制解调加滤波，计算误码率(BPSK distribution, awgn, Ruili fading channel, modulation and demodulation increase filtering, bit error rate calculation)
- 2021-04-08 23:19:00下载
- 积分：1
-
Matlab
说明： matlab入门的基础知识,很好用的,看完后你就懂了(Introduction to the basics of matlab, very good use, you will get it after reading)
- 2010-04-27 01:48:03下载
- 积分：1
-
Link-a-System-Level-OFDM-Simulator
针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.
To start with, go into the folder sys_link_simu, and excute the following commond from matlab:
sys_link_simu_func(a,b)
where a is the link ada)
- 2011-08-09 11:00:53下载
- 积分：1
-
dtw
可实现规整后序列的输出，规整前数据的归一化和反归一化(The output of the normalized sequence can be realized, and the normalization and de-normalization of the pre-normalized data can be realized.)
- 2018-12-03 10:36:59下载
- 积分：1
