-
mostvalurs
/*题目内容：有n件产品，编号分别为0,1,2,3,4,5,6....n-1，它们的重量分别是a[0],a[1],a[2]......a[n-1],它们的价值分别是b[0],b[1].....b[n-1],现在给你个承重为w的背包，如何让背包里装入的物品具有最大的价值总和？
*/ (this is a program that may help you do something )
- 2014-07-24 11:39:22下载
- 积分：1
-
MPU-6000-Register-Map1
MPU6050寄存器介绍和地址地图，方便查询。(MPU6050 register and address map, easy to query.)
- 2017-12-12 21:37:37下载
- 积分：1
-
ATT7022E
ATT7022C的C语言程序，包含测量和校准程序(C ATT7022C language program, including measurement and calibration)
- 2016-09-22 09:08:12下载
- 积分：1
-
实验5 外部中断实验
正点原子STM32F103精英板按键外部中断例程(Punctual Atom STM32F103 Elite Panel Key External Interruption Routine)
- 2020-06-21 11:00:02下载
- 积分：1
-
FSMC—外部SRAM
说明： 基于STM32平台下的FSMC外接SRAM的程序(Program of FSMC external SRAM based on STM32 platform)
- 2020-04-17 14:08:52下载
- 积分：1
-
AC_Compressor_Ctrl
说明： 基于SPMC75的变频电机驱动例子,相当于一个简单的变频器. 望对变频器开发的工程式师有一定的帮助!(SPMC75 based on the frequency motor drive examples, the equivalent of a simple inverter. look for the development of inverter-type division works can help!)
- 2006-02-12 00:30:16下载
- 积分：1
-
STATCOM_PI
采用载波移相和PI控制器的（电流前馈解耦）STATCOM仿真，电路拓扑为H桥级联，实现了直流侧电压的平衡控制(Using STATCOM simulation of carrier phase shift and the PI controller, the circuit topology for the H bridge cascade, the realization of DC side voltage balance control)
- 2014-11-26 10:27:04下载
- 积分：1
-
MPPT1
MPPT，最大功率跟踪，使用STC12R5608AD作主控芯片。原理图，程序完整。直接烧录即可使用。PCB就不上传了，自己画一下。研究生课程设计的作品(MPPT, MPPT using STC12C5608AD as master chip. Schematics, program integrity. Direct burn to use. PCB not uploaded Kazakhstan, she painted it. Graduate course design work)
- 2013-08-20 21:52:28下载
- 积分：1
-
SOC_SMO_Battety
电池SOC估算模型,是MATLAB中的simulink仿真模型，可以估算电池SOC(Battery SOC Estimation Model)
- 2021-03-07 23:49:29下载
- 积分：1
-
led-clock
The LED clock consists of 60 LEDs which are placed circular around a common analog clock. The LEDs are used to display the seconds. Essential part of this circuit is the LED driver MAX7219 from Maxim. A datasheet is available on Maxim s homepage. The clock is controlled by the microcontroller AT89C2051 from Atmel. This microcontroller is clocked at a frequency of 12 MHz from which results a time base of 1 microsecond. Via software dividers one clock impulse per second is generated which is used for updating the LED display.
- 2013-10-17 10:56:37下载
- 积分：1
