-
part2
盲信号处理研究论文，这是第二部分，包括三、四、五章以及摘要和目录。(Blind signal processing research papers, this is the second part, including three, four, five chapters, as well as a summary and directories.)
- 2007-09-24 12:48:38下载
- 积分：1
-
chongfukongzhi
重复控制将“上一次的偏差”储存起来，用于下一次的控制，提高了系统的鲁棒性(Repetitive control of " the last of the deviation" store for the next control, to improve the robustness of the system)
- 2009-05-21 22:33:21下载
- 积分：1
-
disizhangchegnxu
disizhangchegnxu程序集合是北京航空航天大学编写的(disizhangchegnxu collection procedure is to write the Beijing University of Aeronautics and Astronautics)
- 2014-01-13 11:03:01下载
- 积分：1
-
matlab-korea
korea matlab guide
enjoy
- 2013-05-23 16:05:58下载
- 积分：1
-
fig8b
This paper presents a method to operate a grid
connected hybrid system. The hybrid system composed of a Photovoltaic
(PV) array and a Proton exchange membrane fuel cell
(PEMFC) is considered. The PV array normally uses a maximum
power point tracking (MPPT) technique to continuously deliver
the highest power to the load when variations in irradiation and
temperature occur, which make it become an uncontrollable
source. In coordination with PEMFC, the hybrid system output
power becomes controllable. Two operation modes, the unit-power
control (UPC) mode and the feeder-flow control (FFC) mode, can
be applied to the hybrid system. The coordination of two control
modes, the coordination of the PV array and the PEMFC in the
hybrid system, and the determination of reference parameters
are presented
- 2020-12-21 16:29:09下载
- 积分：1
-
filterfeather
关于滤波器性能的各种转换 帮助菜鸟在较短时间内精通滤波器性能的MATLAB表示(About the performance of a variety of conversion filter to help rookie proficient in a relatively short time the performance of MATLAB filter express)
- 2009-03-06 21:02:08下载
- 积分：1
-
filter-simulation
该程序用于实现零相位滤波,求系统的群延迟，调用格式大大简化，通俗易懂。(This is for everyone who is major in the communication project.)
- 2010-05-14 22:55:28下载
- 积分：1
-
baselineremove
去除心电信号中的基线漂移，采用自适应滤波等方法，包括matlab实现程序(baseline remove ，matlab)
- 2012-04-04 16:55:55下载
- 积分：1
-
getiq
在信号分析中，我们常把信号进行矢量分解，也就是将信号分解为频率相同、峰值幅度相同但相位相差90的两个分量。该程序实现将信号分解为I路和Q路。(In signal analysis , we often decompose the signal vector , that is, the signal is decomposed into the same frequency , the peak amplitude of phase 90 of the same, but the two components . The program implementation will signal into I and Q branches .)
- 2014-11-06 16:11:10下载
- 积分：1
-
MatlabFIR
matlab低通滤波器，可直接在matlab运行，显示()
- 2008-03-27 09:31:44下载
- 积分：1
