登录
首页 » matlab » mseq

mseq

于 2020-07-02 发布 文件大小:2KB
0 172
下载积分: 1 下载次数: 80

代码说明:

  根据M序列的产生原理,利用MATLAB编程实现4阶、6阶及任意阶M序列的产生(M sequence generated in accordance with the principle of the use of MATLAB Programming 4 bands, 6 bands and arbitrary selection of sequence-order M )

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • cov2para
    This MATLAB code computes the covariance matrix of a random variable
    2009-12-16 16:44:44下载
    积分:1
  • Matlab_parfor
    当matlab计算量很大,重复独立的循环计算很多的时候,我们可以使用matlab的并行计算,这里我先试验了parfor并行计算。以下代码仅适合新版的matlab,改编自《实战matlab之并行程序设计》。(When MATLAB has a large amount of computation and a lot of repetitive computing, we can use the parallel computing of MATLAB, where I first experimented with parfor parallel computing. The following code is only suitable for the new version of MATLAB, adapted from the parallel programming of real MATLAB.)
    2020-07-03 17:40:02下载
    积分:1
  • dpdsimulation
    说明:  该程序用一种16QAM信号源进行数字预失真的仿真,有一定的参考价值。(The program with a 16QAM signal simulation for digital pre-distortion, there is some reference value.)
    2011-03-08 20:58:15下载
    积分:1
  • antenna-pattern
    有关天线方向图的实现,主要是线阵方向图的实现(The implementation of the antenna pattern, mainly linear array)
    2013-01-18 19:06:17下载
    积分:1
  • chu
    本程序可以实现具有较好相关性的ZC序列,其时频两域相关性很强(The program can achieve better correlation with the ZC sequence, time and frequency domain strong correlation)
    2021-04-11 14:08:58下载
    积分:1
  • 超宽带无线电
    说明:  葛丽嘉的超宽带无线电中的算法,关于uwb波的产生等(Grega's UWB radio algorithm, on the UWB wave generation)
    2021-03-25 09:58:34下载
    积分:1
  • pso2.rar
    基于改进的粒子群算法,可以用来求解函数优化问题(Based on Improved Particle Swarm algorithm, can be used to solve the function optimization problem)
    2009-03-24 21:16:00下载
    积分:1
  • wierlesscommunicationfpgadesignmatlabverilogcode
    无线通信FPGA设计的所有源码,具有良好的使用价值(verilog matlab ISE )
    2009-07-09 21:23:57下载
    积分:1
  • Thbllxjmma
    目标连续声纳回波模型仿真应应用于水下目标回波分析与仿真 (Target for sonar echo simulation model used inn underwater target echo analysis and simulation )
    2012-05-19 22:03:12下载
    积分:1
  • computerwork_1
    1) 借助MATLAB画出误差性能曲面和误差性能曲面的等值曲线; 2) 写出最陡下降法, LMS算法的计算公式( ); 3) 用MATLAB产生方差为0.05,均值为0白噪音S(n),并画出其中一次实现的波形图; 4) 根据2)中的公式,并利用3)中产生的S(n),在1)中的误差性能曲面的等值曲线上叠加画出采用最陡下降法, LMS法时H(n)的在叠代过程中的轨迹曲线。 5)用MATLAB计算并画出LMS法时 随时间n的变化曲线(对 应S(n)的某一次的一次实现)和e(n)波形;某一次实现的结果并不能从统计的角度反映实验的结果的正确性,为得到具有统计特性的实验结果,可用足够多次的实验结果的平均值作为实验的结果。用MATLAB计算并画出LMS法时J(n)的100次实验结果的平均值随时间n的变化曲线。 6)用MATLAB计算并在1)中的误差性能曲面的等值曲线上叠加画出LMS法时100次实验中的H(n)的平均值的轨迹曲线; 7)对以上实验结果给出一些你认为有价值的讨论。 (在实验中n=1,,…..N,N的取值根据实验情况确定,一般选取足够大以使算法达到基本收敛,本题作业以电子文档PDF格式提供) (1) With MATLAB to draw the contours of the error performance surface and error performance surface 2) Write down the steepest descent method, the LMS algorithm formula () 3) using MATLAB variance 0.05, mean 0 white noise S (n), and draw one to achieve the waveform diagram 4) According to the formula 2), and using 3) S (n) produced in 1), the error performance of the contours of the surfaces superimposed on draw using the steepest descent method, the LMS method is H (n) in the iterative process in the trajectory curve. 5) curve to calculate and draw the LMS method using MATLAB with time n (time corresponding to the S (n) of a first implementation) and e (n) waveform reflect a certain time to achieve results not from a statistical point of experiment the correctness of the results obtained with the experimental results of the statistical properties of the available sufficient times the average of the experimental results as a result of the experiment. Calculate and draw the LMS m)
    2020-12-14 14:29:14下载
    积分:1
  • 696518资源总数
  • 105885会员总数
  • 31今日下载