-
i2c
IIC驱动,改变宏定义管脚即可直接使用，非常方便！！！(IIC Driver, Change the macro definition pin can be directly used, very convenient!!!)
- 2020-06-18 15:00:01下载
- 积分：1
-
music51_1
51单片机驱动无源蜂鸣器进行音乐输出1
使用了定时器，使用C51编译(51 Microprocessor Passive buzzer for the use of music output of a timer, the use of C51 compiler)
- 2007-02-26 11:54:49下载
- 积分：1
-
28335_ECAN_1PROGRAM
参考ti提供得例子程序，先将他们得例子在自己得板子上跑起来，其实就是用自测试得方式来验证一下程序，也可以加些中断，看看程序怎么跑得。这步没问题得话，可以改写程序，当然还在自测试模式下先试，如果可以改写后，在自测试模式下可以。那么就差不多了，将自测试模式改成正常模式，将程序移植到自己得程序中，拿一个经过验证可以正常通讯得can模块通讯，记得两个can得速率要一致。当然这个can模块还要能让你看到或者说能验证你得can是否通讯正常。(Reference ti provide examples of procedures was, first they have to run up on the example of the board that she has, in fact, self-test was used to verify the program mode, you can also add some interruption to see how to run the program. This step was not a problem, you can rewrite the program, of course, still in test mode since the first try, if you can rewrite, can in self-test mode. Well almost, the self-test mode to normal mode, the program was ported to own program, get a proven module can communicate normally too can communicate, remember that two can get a rate to be consistent. Of course, this can also allow you to see the module or can verify whether you have can communicate properly.)
- 2014-07-10 20:13:37下载
- 积分：1
-
心率血氧串口发送
max30100 stm32 驱动参考例程(Max30100stm32 Driver Reference Routine)
- 2020-06-22 14:20:02下载
- 积分：1
-
FreeRTOS实验15-1 FreeRTOS软件定时器实验
硬件资源:
1,DS0(连接在PA8)，DS1(连接在PD2上)
2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏)
4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
实验现象:
通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是
周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0
可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次，
运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources:
1, DS0 (connected to PA8), DS1 (connected to PD2)
2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen)
4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
Experimental phenomena:
The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is
The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0
You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once.
The run cycle will stop after that unless KEY0 is pressed to turn it on again.)
- 2020-06-24 05:00:01下载
- 积分：1
-
Calculate-the-position-of-the-sun
计算太阳位置，通过公式！用单片机编译程序！(Calculate the position of the sun through the formula! Microcontroller compiler!)
- 2012-12-18 22:09:24下载
- 积分：1
-
transmitter-module-
发射端程序 单片机STC15L204EA 发射模块NRF24L01(NRF24L01 transmitter module STC15L204EA)
- 2015-11-27 14:17:11下载
- 积分：1
-
compare
几种传统滤波方法如kuan、frost、SBF、srad代码以及比较代码(Several traditional filtering methods and code comparison code)
- 2020-11-12 17:39:44下载
- 积分：1
-
mini-voltmeter
mini voltmeter using bascom
- 2011-09-23 10:04:08下载
- 积分：1
-
PID闭环运算恒压供水
说明： S7-1200 PLC程序，PID闭环恒压供水PLC程序(PID closed loop constant pressure water supply PLC program)
- 2020-08-01 23:45:07下载
- 积分：1
