-
职责链模式-基本代码
遗传算法求解车辆路径问题,采用C#编写，计算结果以及计算结果的可视化显示(The genetic algorithm is used to solve the vehicle routing problem, which is compiled by C#, and the results are visualized.)
- 2020-06-24 08:20:02下载
- 积分：1
-
Xamarin_Forms___Todo
说明： xamarin forms todo sample
- 2020-02-04 20:26:18下载
- 积分：1
-
LSTM-IMDB
说明： 迭代算法的收敛率p是等于矩阵导数的最大特征根,Jacobi矩阵表示的是信息缺失的比例,所以p是一个可以有效的表示缺失信息的一个比例的标量,缺失信息的比例其实就是单位矩阵I 减去已经观测到的信息占完全信息的比例(The convergence rate P of the iterative algorithm is equal to the maximum characteristic root of the matrix derivative. Jacobi matrix represents the proportion of missing information, so P is a scalar that can effectively represent a proportion of missing information. The proportion of missing information is actually the proportion of the unit matrix I minus the observed information to the complete information.)
- 2021-04-15 17:42:45下载
- 积分：1
-
C俄罗斯方块.h代码
C俄罗斯方块.h，把整个文件代码下载整理后打包了，在此分享给大家，用C写的俄罗斯方块游戏代码。
- 2022-05-07 17:45:34下载
- 积分：1
-
GameProphet公开版
说明： 使用GG修改器运行就可以了，注意是最新版(Just run it with the GG modifier, note the latest version)
- 2020-06-23 02:00:02下载
- 积分：1
-
ConvertTDMS-master
说明： 这里解压后，matlab读取TDMS文件的一种格式，打开后，文件有两个M函数，一般而言，我们用CONVERTtdms(matlab read tdms folder)
- 2020-04-20 18:21:29下载
- 积分：1
-
SKRETD(low_power)
硕士论文，viterbi译码器的低功耗设计，最后附带源码，VHDL(master's thesis, Viterbi Decoder low-power design, the final collateral source, VHDL)
- 2006-06-08 23:11:39下载
- 积分：1
-
有限单元法及计算程序
有限单元法及计算程序 (王焕定 吴德伦1997，哈尔滨建筑大学)(Finite Element Method and Computing Program (Wang Huanding, Wu Delun, 1997, Harbin University of Architecture))
- 2020-06-18 05:40:01下载
- 积分：1
-
4bit_8bit_lcd
AT80S52 4&8-bit lcd interface
- 2020-06-21 01:00:02下载
- 积分：1
-
下垂控制
说明： 所谓下垂控制就是选择与传统发电机相似的频率一次下垂特性曲线（Droop Character）作为微源的控制方式，即分别通过P/f下垂控制和Q/V下垂控制来获取稳定的频率和电压，这种控制方法对微网中的微源输出的有功功率和无功功率分别进行控制，无需机组间的通信协调，实现了微源即插即用和对等控制的目标，保证了孤岛下微电网内电力平衡和频率的统一，具有简单可靠的特点(The so-called droop control is to select the Droop Character, which is similar to the traditional generator, as the control mode of micro-source. That is to say, the stable frequency and voltage are obtained by P/f droop control and Q/V droop control respectively. This control method controls the active power and reactive power of micro-source output in the micro-grid separately, without the need of communication coordination between the units. It realizes the goal of micro-source plug-and-play and peer-to-peer control, guarantees the unification of power balance and frequency in micro-grid under islands, and has the characteristics of simplicity and reliability.)
- 2019-01-26 21:07:14下载
- 积分：1
