-
MFCStatus
parker acr9000运动控制器上位机程序开发例子，主要包括控制器连接和断开以及读取变量(Parker acr9000 motion controller PC program development example, mainly including controller connect and disconnect and read the variable)
- 2020-09-10 05:08:03下载
- 积分：1
-
jidianqi
程序是用stm32输出来的信号来控制继电器的开通与否，继而来控制电机的状态(Program is with stm32 output signal to control the opening of relay or not, and then to control the state of the motor
)
- 2013-09-11 14:23:27下载
- 积分：1
-
模拟智能灌溉
说明： 蓝桥杯单片机，模拟智能灌溉，亲测是对的！(Blue Bridge Cup MCU, simulate intelligent irrigation, pro-test is right!)
- 2019-07-10 23:48:07下载
- 积分：1
-
PWM
用C语言编程的PWM波在液晶屏上的显示，主控制器为单片机(C language programming of the PWM wave display on the LCD screen, the main controller for the microcontroller)
- 2013-08-15 11:22:45下载
- 积分：1
-
PWM_test
没有使用ADS，是搭建在keil下的s3c2440裸机程序，实现TOUT0的PWM输出来控制舵机(No use ADS, is to build a bare-metal s3c2440 in keil procedures to achieve TOUT0 PWM output to control steering)
- 2014-06-01 20:47:10下载
- 积分：1
-
001
基于51单片机的出租车计价器系统设计，包含protues仿真电路和程序(Taximeter system design based on MCU 51 taxi, including Protues simulation circuit and program)
- 2013-08-24 13:06:03下载
- 积分：1
-
实验报告
智能仪表硬件系统测试程序
蜂鸣器自检：确定蜂鸣器正确
LED（LCD） 显示器自检：确定LED（LCD） 显示器每一段均正确
键盘自检： 确定键盘正确
④其他(Intelligent Instrument Hardware System Test Program
Buzzer self-test: confirm that buzzer is correct
LED (LCD) Display Self-Check: Make sure that every segment of the LED (LCD) display is correct
Keyboard Self-Check: Make sure the keyboard is correct)
- 2019-05-10 17:37:49下载
- 积分：1
-
LCD
用C语言编写STM32嵌入式程序，设计一个万年历系统，并用HX1230屏显示相关的时间信息。
基本要求：
1.C语言程序要求是模块化设计。
2.该万年历要求能显示时间（时、分、秒）、年月日及闹钟定时时间（分、秒）。
3.该系统由2-3个按键可调整显示的时间、年月日及闹钟定时时间，具体各个按键功能及编程方式自定。
4.该闹钟可以定时时间到，LED将发出提示闪光，且持续30s。
5.HX1230屏能驱动显示。
6.定时时间可被打断，即打断后恢复时继续计时。
7.设置闹钟报警功能；
8.利用STM32自带的温度传感器功能，使系统能显示当前环境温度值。(STM32 embedded program is written in C language, a calendar system is designed, and relevant time information is displayed on HX1230 screen.
Basic requirements:
1. The requirement of C language program is modular design.
The calendar requires that time (hours, minutes, seconds), year, month, day and alarm clock timing time (minutes, seconds) be displayed.
3. The system can adjust the display time, year, month, day and alarm clock timing time by 2-3 keys, and the function and programming mode of each key are self-determined.
4. The alarm clock can be scheduled to arrive, and the LED will give a prompt to flash, and lasts for 30 seconds.
5. HX1230 screen can drive display.
6. Timing time can be interrupted, i.e. when the interruption is resumed, the timing will continue.
7. Setting alarm function of alarm clock;
8. Using the temperature sensor function of STM32, the system can display the current environmental temperature)
- 2020-06-25 05:00:02下载
- 积分：1
-
E-BIKE-BMS-SCH-FOR-E-BIKE
采用赛普拉斯公司CY8C34XX 方案，实现13串锂电池包智能管理BMS(BMS schematic for E-BIKE manage 13S lion battery package,using CY8C34XX solution.)
- 2013-05-28 10:40:30下载
- 积分：1
-
LQmma7455C52
单片机内刻录程序，包含C语言和汇编语言两个版本。实现7455C5与单片机的串口通信，信息传输。(Microcontroller burning program, contains two versions of the C and assembly language. 7455C5 microcontroller serial communication, information transfer.)
- 2013-01-31 16:38:03下载
- 积分：1
