登录
首页 » Fortran » inverter_4Quadrant

inverter_4Quadrant

于 2016-07-26 发布 文件大小:7KB
0 131
下载积分: 1 下载次数: 18

代码说明:

  PSCAD 仿真,交直流潮流控制器,4象限运行(PSCAD GROGRAM,INVERTER ,4QUADRANT RUN)

文件列表:

inverter_4Quadrant.psc,51768,2016-07-22

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • signal
    本系统以单片机AT89C52为核心,以数模转换器DAC0832实现方波、正弦波、三角波、锯齿波波形的输出,实现信号发生器的简易功能。(This system with single chip microcomputer AT89C52 as the core, with digital to analog converter DAC0832 achieve square wave, sine wave, triangle wave, sawtooth wave form output, realize the simple function of the signal generator.)
    2020-11-02 17:19:53下载
    积分:1
  • XX-DHT11
    DHT11的C51驱动程序,4位数码管可以显示温度和湿度,带一触发按键(DHT11 C51 driver, four digital tube can display temperature and humidity, with a trigger button)
    2013-11-27 14:14:59下载
    积分:1
  • FontGen2
    点阵字体产生工具以及相关显示函数。 在开发嵌入式系统时,需要显示不同大小或类型字体的汉字。显然,对于嵌入式系统,不太可能使用矢量字体,而点阵字体,不同大小的字体不能简单的缩放。 另外,对一个小系统,也不需要完整的字体,往往只要几十个,甚至几个就够了。 一般,我们采用的方法是,自己准备点阵字体的数据,在显示汉字时,把这些数据写入显存就行了。 这时又存在另外一个问题,由于是不完整的字库,不能简单的用汉字的内码去找到对应的字体数据,如果逐个比较,又费时间。比较好的方法就是把字体数据排序,用二分法查找,这样可以大大提高查找效率。 这里为以上问题提供了一个完整的解决方案: 产生字体数据:指定字体类型、大小,自动产生字体数据。 字体数据排序:可以按Unicode,也可以按Ansi排序。 集成显示函数:提供相关显示函数。为了节省空间,我们把文字分成thin和wide两种,前者用于显示传统的ASCII字符集,后者用于显示汉字等多(双)字节字符 ()
    2020-06-30 09:20:02下载
    积分:1
  • t_ctrl_pid
    蒸汽锅炉水温控制完整代码,单片机型号为AT89S52,开发环境keil(The steam boiler water temperature control of the full code MCU models for the AT89S52 is the development environment keil)
    2012-05-20 21:03:43下载
    积分:1
  • dds-fw
    基于msp430的DDS芯片ad9851的源码,(MSP430 Based on the DDS chip AD9851 source,)
    2008-08-02 20:18:29下载
    积分:1
  • aa
    说明:  单片机做的万年历公历农历转换代码,用的C语言(SCM calendar Lunar calendar to do the conversion code, using the C language)
    2010-09-22 08:55:30下载
    积分:1
  • 12
    说明:  基于单片机的电阻测量系统,带vb上位机控制和显示同时还有无线发射(MCU-based resistance measurement system with vb PC control and display as well as a wireless transmitter)
    2014-02-22 15:14:06下载
    积分:1
  • 12f629-led-adjust
    超简单断电复原3档亮度调光程序,每次开机都是低亮,不晃眼 低亮不是使用Pwm,而是使用电阻漏一部分电流给LED,超省电,无频闪,亮度随便调 源程序是东成的(3 super simple file recovery power brightness dimming process, each boot are low-light, non-dazzling light rather than the use of low-Pwm, but part of the use of resistance leakage current to the LED, ultra-low power, no strobe, just tune brightness source procedures of the East into)
    2009-07-14 10:36:43下载
    积分:1
  • cheng
    滤波器广泛应用于数字信号处理、通信、自动控制领域,但设计可变宽频带有源滤波器则比较困难。利用单片机控制参数可编程的双二阶通用开关电容有源滤波器,精确设置有源滤波器的中心频率f,品质因数Q及有源滤波器的工作方式。本系统主要分为两个部分:即程控滤波器和程控放大器。程控放大器电压增益为40dB,通过单片机控制DA进行分压,可精确实现要求的10dB步进,误差小于0.5 ,通带为100Hz-500KHz,输入电压峰-峰值范围为10mV,在输入范围内无明显失真。由MAX264为核心的滤波器,可设置为高通、低通滤波器。通过单片机直接给出控制频率,使-3dB截止频率在1KHz-20KHz内可调,步进1KHz,误差小于1 。整个系统以52单片机为控制核心,电路简单,性能稳定,且具有较高精度,滤波参数调节通过单片机控制,较为方便。(Filters are widely used in digital signal processing, communications, automatic control area, but the design variable wideband active filter is more difficult. Control parameters using single-chip programmable universal switched-capacitor biquad active filter, active filter accurately set the center frequency f, quality factor Q and the active filter works. The system is mainly divided into two parts: the program-controlled filters and programmable amplifiers. Programmable amplifier voltage gain of 40dB, the DA through the partial pressure of single-chip control, can accurately achieve the required 10dB step, the error is less than 0.5 , passband to 100Hz-500KHz, input voltage peak- the range of 10mV, the input range no significant distortion. By the MAX264 as the core of filter can be set to high pass, low pass filter. Given directly by the microcontroller controls the frequency, the-3dB cutoff frequency at 1KHz-20KHz adjustable, step 1KHz, error is less than 1 . The entire system for)
    2011-07-17 16:23:27下载
    积分:1
  • laowai
    采样法生成三相SPWM波的开环调速控制程序载波频率为20KHz,或载波周期为50μs。DSP晶振10MHz,内部4倍频,时钟频率为40MHz,计数周期为25ns。假设调制波频率由外部输入(1~50Hz),并转换成合适的格式(Sampling method to generate three-phase SPWM wave open-loop speed control procedures for the carrier frequency 20KHz, or carrier period is 50μs. DSP crystal 10MHz, internal 4 multiplier, the clock frequency of 40MHz, counting cycle 25ns. Assuming wave frequency modulation by external input (1 ~ 50Hz), and converted into a suitable format)
    2009-02-08 18:58:52下载
    积分:1
  • 696518资源总数
  • 105885会员总数
  • 31今日下载