登录
首页 » matlab » D2D Power Control

D2D Power Control

于 2018-01-02 发布 文件大小:58KB
0 268
下载积分: 1 下载次数: 27

代码说明:

  无线通信中,设备到设备技术的控制可控制,提高抗干扰能力,频谱利用率(In wireless communications, control of equipment-to-equipment technology can be controlled to improve anti-interference ability, spectrum utilization)

文件列表:

Power Control\main6_2.m, 460 , 2017-04-09
Power Control\PC_close6.m, 7159 , 2017-03-17
Power Control\PC_my6.m, 7907 , 2016-05-17
Power Control\PC_open6.m, 7794 , 2017-03-17
Power Control\Results\1.fig, 10771 , 2017-03-16
Power Control\Results\2.bmp, 236278 , 2017-03-16
Power Control\Results\3.bmp, 236278 , 2017-03-16
Power Control\Results\4.bmp, 237958 , 2017-03-16
Power Control\Results\5.bmp, 236278 , 2017-03-16
Power Control\Results\6.bmp, 236278 , 2017-03-16
Power Control\Results\7.bmp, 236278 , 2017-03-16
Power Control\Results\8.bmp, 236278 , 2017-03-16
Power Control\Results, 0 , 2017-08-15
Power Control, 0 , 2017-08-15

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Low-Density-Party-Check-codes
    1962年Gallager提出LDPC的博士论文,堪称经典(1962 Gallager LDPC proposed doctoral dissertation, a classic)
    2015-04-16 22:43:55下载
    积分:1
  • LDPC
    实现了LDPC码的编码 LDPC译码、LDPC校验矩阵的生成等。是完整的LDPC代码。测试了,跑的通。自学LDPC码的资料(Implements the LDPC encoding of LDPC decoding, LDPC check matrix generation and so on. LDPC code is complete. Tested and run through. Self-study of LDPC codes)
    2013-04-27 08:46:53下载
    积分:1
  • LS_ChannelEstimation
    说明:  基于MATLAB的OFDM信道估计算法,使用了PN序列作为导频,两种导频处信道估计处理方法,中间特别加入了相位估计处理(MATLAB-based channel estimation algorithm for OFDM using PN sequence as a pilot and two pilot channel estimation Department treatment methods, particularly the middle to join the treatment phase estimation)
    2008-10-13 17:21:37下载
    积分:1
  • Stability-of-Time-Delay-Systems__Control_Engineer
    a reference book about stability of time delay systems
    2012-04-17 21:26:38下载
    积分:1
  • BOC信号频谱相关特性
    说明:  MATLAB代码,产生GNSS导航信号BOC调制的相关频谱特性(The generate of BOC signal AND ITS PDF)
    2019-01-14 15:54:05下载
    积分:1
  • HARQ
    MATLAB实现了HARQ重传,分析误码率和信噪比间的关系,并可以修改最大重传次数(MATLAB implements the retransmission of HARQ, analyzes the relationship between the bit error rate and the signal to noise ratio, and can modify the maximum retransmission times.)
    2018-03-04 13:05:31下载
    积分:1
  • SCFDE
    该算法是迄今为止我找到的最好的最完整的单载波频域均衡的原理。众所周知,时域均衡一直是接收机的瓶颈能估,频域均衡则要简单的多。频域均衡使用基于块传输的机制,类似于OFDM,并且是单载波的。接收机十分完整,包含载波同步、帧同步等,最重要的均衡处理。(This algorithm is the best and the most complete single carrier frequency domain equalization principle I have found so far. As we all know, time domain equalization is always the bottleneck of the receiver, and frequency domain equalization is much simpler. Frequency domain equalization is based on block transmission mechanism, which is similar to OFDM and is single carrier. The receiver is very complete, including carrier synchronization, frame synchronization, and so on, the most important equalization processing.)
    2021-05-13 17:30:02下载
    积分:1
  • 6
    说明:  6. 在三条径的瑞利信道中,对于OFDM: (1) 请设计一种具体的导引辅助的信道估计方法,用Simulink进行仿真。画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已同步,请设计OFDM一种具体的采用循环前缀进行时间同步方法,用Simulink进行仿真,画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已同步,请设计OFDM一种具体的采用循环前缀进行频率同步方法,用Simulink进行仿真,画出比特信噪比与频率同步误差的关系曲线。(6. In the three-path Rayleigh channel, for OFDM: (1) please design a specific navigation-assisted channel estimation method and use Simulink for simulation.The relation curves of bit signal-noise ratio and channel estimation mean square error and the relation curves of bit signal-noise ratio and bit error rate are drawn. (2) if the frequency has been synchronized, please design a specific method of time synchronization using cyclic prefix in OFDM. Simulink is used for simulation to draw the relationship curve between bit-snr and acquisition probability. (3) if time has been synchronized, please design a specific method of frequency synchronization using cyclic prefix in OFDM. Simulink is used for simulation to draw the relationship curve between bit signal-to-noise ratio and frequency synchronization error.)
    2019-01-15 10:59:38下载
    积分:1
  • prbs
    说明:  generate prbs pattern
    2020-06-17 02:00:01下载
    积分:1
  • 信捷PLC
    用于信捷PLC与Labview之间的通信,可以作为学习的初版(Used for the communication between Sinjie PLC and Labview, it can be used as the first edition of learning.)
    2020-06-21 15:00:02下载
    积分:1
  • 696516资源总数
  • 106562会员总数
  • 4今日下载