-
renesas_usb_3.0.23.0
瑞萨的USB3.0扩展卡驱动程序(Renesas USB3.0 expansion card driver
)
- 2015-07-21 10:26:18下载
- 积分：1
-
I2cAnalyzerDll
如果正在学习USB相关的可以参考，上位机提供了动态库及源码，如果写应用界面可直接调用动态库即可，无须对底层做过多了解，但这些也只属于一个初始框架，希望哪位有VC++经验而且有兴趣的，可以细化并提供出一个更好的供广大爱好者使用
(If you are USB-related learning can refer to the host computer provides a dynamic library and source code, if written application interface DLL can be called directly, no need to do too much understanding of the underlying, but these are only part of an initial framework to which There VC++ experience and are interested, you can refine and provide a better use for the majority of fans)
- 2013-07-10 11:03:43下载
- 积分：1
-
hanshuxinhaofashengqi
1．采用Labview设计一虚拟函数信号发生器， 通过数据采集卡输出波形信号，调节信号的相关参数，可观察示波器上波形的变化情况。
⑴ 以NI MyDAQ数据采集卡作为输出接口；
⑵ 数据采集卡输出多种信号，至少完成三种波形：正弦波、三角波、方波(可调占空比)的输出，同时前面板上显示各输出波形；
⑶ 频率、幅值、初相位、直流偏移量和方波的占空比（0～100 ）等参数可以通过前面板控件调节。
⑷ 前面板可显示输出波形。(1. Labview design using a virtual function signal generator, data acquisition card output waveform signal, adjust the relevant parameters of the signal can be observed on an oscilloscope waveform changes.
⑴ with NI MyDAQ data acquisition card as output interface
⑵ data acquisition card output a variety of signals, to complete at least three waveforms: sine wave output, triangle wave, square wave (adjustable duty cycle), while each of the output waveform is displayed on the front panel
⑶ frequency, amplitude, initial phase, the DC offset and duty cycle square wave (0 to 100 ) and other parameters via the front panel controls to adjust.
⑷ output waveform can be displayed on the front panel.)
- 2015-04-25 18:26:52下载
- 积分：1
-
SyncReadWrite
说明： gpib 输入、输出,ADLINK’s LPCI-3488A and USB-3488A GPIB controller interface
cards are fully compatible with the IEEE488.2 instrumentation control
and communication standard and are capable of controlling up
to 14 stand-alone instruments via IEEE488 cables.(gpib input & OUTADLINK’s LPCI-3488A and USB-3488A GPIB controller interface
cards are fully compatible with the IEEE488.2 instrumentation control
and communication standard and are capable of controlling up
to 14 stand-alone instruments via IEEE488 cables.)
- 2010-04-01 21:50:53下载
- 积分：1
-
Subpanelzairu
LabVIEW环境下动态载入技术，个人编写的，在8.5版本下可以运行，很好的！(LabVIEW environment, dynamic loading technology, personal written version may be run at 8.5, very good!)
- 2010-06-01 11:25:37下载
- 积分：1
-
test01
利用labvIEW实现串口接收数据并实时显示波形的简单功能。(Use labvIEW Serial receive data and real-time waveform display a simple function.)
- 2013-09-12 09:59:22下载
- 积分：1
-
yuyincaijixitong
基于labview的语音采集系统，可以进行录音等操作。为北京理工大学实验课结课作业。(Labview-based voice acquisition system, recording and other operations can be performed. Experimental course for the Beijing Institute of Technology knot class job.)
- 2013-10-20 22:25:51下载
- 积分：1
-
The-electrical-system-LabVIEW
LabVIEW心电检测系统，主要是滤波 信号采集 频谱分析 显示波形等(LabVIEW ECG detection system is mainly filtered signal acquisition spectrum analysis shows waveforms)
- 2013-08-29 17:34:25下载
- 积分：1
-
VCDLL
在vc环境下调用labview下生成的dll库在vc环境下调用labview下生成的dll库(Vc calls in labview environment generated dll library vc environment in labview generated call dll library)
- 2009-07-08 00:26:08下载
- 积分：1
-
power-measure-labview
实现功率信号谱的测量，功能丰富，可测性较强，能够实现复杂功能(Achieve power signal spectrum measurement, feature-rich, testability strong, complex functions can be achieved)
- 2014-01-05 13:29:56下载
- 积分：1
