登录
首页 » matlab » SUDHEER_fdlf

SUDHEER_fdlf

于 2018-11-26 发布 文件大小:2KB
0 182
下载积分: 1 下载次数: 2

代码说明:

  基于matlab的典型IEEE 9节点系统潮流计算(matlab, ieee 9, load flow)

文件列表:

SUDHEER_fdlf.m, 3633 , 2012-11-10
license.txt, 1520 , 2014-02-12

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Integral
    操作数值积分的类 CIntegral 的实现代码(Operation of numerical integration code for the class implementation of CIntegral)
    2010-01-18 22:16:26下载
    积分:1
  • Code_Pudn
    IMAGE ENHANCEMENT METHODS, ACTIVE CONTOUR WITHOUT EDGES, MANUAL THRESHOLD CODES
    2012-05-02 23:00:45下载
    积分:1
  • wavemin
    creates a minimum phase wavelet for impulsive sources
    2011-10-23 19:03:49下载
    积分:1
  • main_CirArray_LCMV
    阵列天线抗干扰 圆阵等高线,波束方向及三位角度信噪图(Array antenna interference contours, angle of beam direction and three noise graph)
    2010-10-13 20:20:57下载
    积分:1
  • 26964185
    说明:  基于CRAFT的多阶段柔性设备布局优化算法   多阶段设备布局下的总成本包括设备拆装成本、物料搬运成本以及区域利用成本,问题的目标是最小化总成本。首先,在分析问题的基础上,建立基于多阶段设备布局优化目标的数学模型 其次,采用改进的CRAFT启发式算法优化单阶段设备布局 进一步,提出基于单阶段设备布局算法的多阶段启发式算法,优化多阶段设备布局 最后,数值实验表明算法优化后总成本降幅达28.57%. (CRAFT-based multi-stage flexible equipment layout optimization algorithm under the multi-stage equipment, the layout of the total cost including equipment disassembly cost, material handling costs as well as regional use of cost, the goal is to minimize the total cost. First of all, the analysis of the problem on the basis of the equipment based on the layout of multi-stage mathematical model of optimization objectives Secondly, the adoption of improved CRAFT heuristic algorithm to optimize the layout of single-stage device to further, based on equipment layout algorithm for single-stage multi-stage heuristic algorithm, optimize the layout of multi-stage equipment Finally, numerical experiments show that the optimized algorithm for the total cost of 28.57 percent decrease.)
    2008-10-17 09:39:38下载
    积分:1
  • neural-network-toolbox
    本文介绍在Matlab 环境下发电厂水位控制BP 模型的建模与仿真方法, 得出了预测模型的最优参数。仿真结果表明, MATLAB 神经网络工具箱可有效地用来解决复杂的非线性控制系统的优化设计问题。(This article describes the Matlab environment plant level control BP Model modeling and simulation methods, predictive models obtained optimal parameters. Simulation results show that, MATLAB Neural Network Toolbox can be effectively used to solve complex nonlinear control system optimization design problems.)
    2013-09-02 08:55:40下载
    积分:1
  • robert
    灰度图像边缘检测中的robert算法的MATLAB仿真实现(MATLAB simulation grayscale image roert edge detection algorithm to achieve)
    2014-11-03 15:29:02下载
    积分:1
  • FIR
    四种窗函数设计FIR数字滤波器matlab源码(hant,hamming,blackman,kaiser)(use window functions to design digital low-pass FIR filter...)
    2009-04-07 12:22:27下载
    积分:1
  • chengxu
    数字信号的传输:1、实现滚降系数分别为0,0.5,1时信号时域频域和功率谱密度以及眼图的波形,并比较异同。 2、对(2/4/8)PSK,DPSK通信系统进行蒙特卡罗仿真,通过功率谱密度、误比特率来比较他们的性能(采用最佳接收方式)。 (Digital signal transmission: 1, to achieve roll-off coefficients were 0,0.5,1 time domain when the signal frequency and power spectral density, as well as eye-diagram of the waveform, and compare the similarities and differences. 2, (2/4/8) PSK, DPSK communication system, Monte Carlo simulation, through the power spectral density, bit error rate to compare their performance (to adopt the best way to receive).)
    2008-06-28 10:06:51下载
    积分:1
  • QAM
    QAM的系统调制与解调的MATLAB程序 (QAM modulation and demodulation system)
    2010-05-17 19:15:58下载
    积分:1
  • 696518资源总数
  • 105540会员总数
  • 37今日下载