登录
首页 » matlab » 光伏分布式

光伏分布式

于 2018-11-29 发布 文件大小:431KB
0 253
下载积分: 1 下载次数: 14

代码说明:

  实现光伏分布式大楼中光伏功率计算,同时依据电跟随方式,可以实现燃气轮机变工况(The calculation of photovoltaic power in photovoltaic distributed building can be realized. At the same time, the off-design condition of gas turbine can be realized according to the electric following mode.)

文件列表:

fenbu.m, 2227 , 2018-11-28
张北地区气象数据.xlsx, 321591 , 2018-11-28
大楼负荷.xlsx, 137544 , 2018-11-28

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Projectile-launch-angle-problem
    炮弹发射视为斜抛运动,已知初始速度为200m/s,问要击中水平距离360m、垂直距离160m的目标,当忽略空气阻力时,发射角应多大?此时炮弹的运行轨迹如何?(Projectile launch angle problem )
    2011-05-26 00:19:53下载
    积分:1
  • fullwave_inverters
    Full wave inverter for power electronics applications as wind trtansformation
    2015-01-28 09:39:00下载
    积分:1
  • benchmark
    optimization of benchmark function by different methods
    2012-11-22 17:36:04下载
    积分:1
  • phasor
    PLOTTING PHASOR QUANTITIES USING MATLAB IN PSCAD A simple case which uses MATLAB for ploting phasor quantities. Apply the fault during simulation run and observe phasor quantities (you can change type of fault) WARNING * This case only works if you use the Compaq/Intel Fortran Compiler. (PLOTTING PHASOR QUANTITIES USING MATLAB IN PSCAD A simple case which uses MATLAB for ploting phasor quantities. Apply the fault during simulation run and observe phasor quantities (you can change type of fault) WARNING * This case only works if you use the Compaq/Intel Fortran Compiler. )
    2014-01-04 09:44:02下载
    积分:1
  • SER
    Comparison of the performances of the LS and the MMSE channel estimators
    2009-04-12 14:05:00下载
    积分:1
  • ebp1
    神经网络,可以运行成功 主要用于图像的分类等方面(Neural Network examples)
    2009-04-28 00:46:10下载
    积分:1
  • ditonglvbo
    MATLAB低通滤波程序,很好的源代码,希望对大家有用(filter)
    2009-11-26 11:37:15下载
    积分:1
  • CatastrophicCodes
    恶性码(灾难码)的仿真,计算不同信噪比下的PER和SER(MATLAB code used to calculate P[k] for each SNR. The output is then used to calculate the PER as 1− P[k = 0] and the BER)
    2011-09-28 22:55:48下载
    积分:1
  • DSP
    任务: 1) 借助MATLAB画出误差性能曲面和误差性能曲面的等值曲线(参考PPT2.1第17页的两幅图); 2) 写出最陡下降法以及LMS算法的计算公式(取 ); 3) 用MATLAB产生方差为0.05, 均值为0白噪音S(n),并画出某次采样得到的波形(即产生任意一个噪声随机序列); 4) 根据 2)中的公式,并利用 3)中产生的S(n),在 1)中的误差性能曲面的等值曲线上叠加画出采用最陡下降法以及LMS法时H(n)的在叠代过程中的轨迹曲线(参考PPT2.1第17页的右下图的曲线1和曲线2)。 5)用MATLAB计算并画出LMS法时 随时间n的变化曲线(对应S(n)的某一次的一次实现)和e(n)波形; 注意:某一次实现的结果并不能从统计的角度反映实验的结果 的正确性,为得到具有统计特性的实验结果,可用足够多次的 实验结果的平均值作为实验的结果。用MATLAB计算并画出 采用LMS法时,J(n)的100次实验结果的平均值随时间n的变 化曲线(即 生成随机噪声信号并计算结果,重复执行100次, 求平均结果)。 6)在 1)中的误差性能曲面的等值曲线上,叠加画出采用LMS法得到的100次实验中的H(n)的平均值的轨迹曲线; (Task: 1 ) Draw with MATLAB error performance surface and surface contour error performance curve ( refer PPT2.1 two chart on page 17 ) 2 ) Write the steepest descent method and the LMS algorithm formula ( take ) 3 ) Using MATLAB to generate variance of 0.05 with a mean of 0 white noise S (n), and draw a particular sampling waveform ( ie, any noise generated random sequence ) 4 ) based on 2 ) of the formula , and use 3 ) generated in S (n), in a ) the error performance curves superimposed on the surface contour plot using the steepest descent method and the LMS method when H (n) the iterative process in the trajectory curve ( refer PPT2.1 page 17 bottom right of the curves 1 and 2 ) . 5 ) using MATLAB LMS method is used calculate and draw the curve with time n (corresponding to S (n) of a first implementation of a ) and e (n) waveform Note : in a first implementation of the results are not reflected from a statistical point of view of accuracy of the experimental results ,)
    2013-11-08 20:09:06下载
    积分:1
  • GUDAO
    一个关于孤岛效应的仿真,尽量模拟电力系统孤岛效应(A simulation on the island effect, try to simulate the power system islanding)
    2014-12-12 09:35:29下载
    积分:1
  • 696518资源总数
  • 106148会员总数
  • 10今日下载