-
27796714system
说明： ieee 14 bus system, 用于网络潮流计算，PQ节点替换(ieee 14 bus system in electricity netwroks)
- 2020-06-16 05:00:01下载
- 积分：1
-
Pan_Tompkins_ECG_v8
ECG code for QRS detection
- 2020-12-09 06:49:20下载
- 积分：1
-
STM32_USBDevice_UVC
说明： STM32的虚拟串口，以野火的F29为例(Virtual serial port of stm32)
- 2020-09-14 16:04:45下载
- 积分：1
-
角速度与加速度仿真
说明： 惯性导航系统是以陀螺和加速度计为敏感器件的导航参数解算系统，该系统根据陀螺的输出建立起导航坐标系，根据加速度计输出解算出运载体的速度和位置。本程序依据比力坐标变换和姿态阵解算的方法，利用MATLAB仿真捷联式惯导系统中陀螺和加速度计的输出，得到角速度和加速度仿真数据。
本仿真可作为课程学习的参考例程，也可作为撰写期刊论文的基础例程，“main_model.m”是主程序，各子模块均有注释。(Inertial navigation system (INS) is a navigation parameter calculation system with gyroscope and accelerometer as sensitive devices. The navigation coordinate system is established according to the output of gyroscope, and the speed and position of carrier are calculated according to the output of accelerometer. According to the method of specific force coordinate transformation and attitude matrix calculation, the output of gyro and accelerometer in strapdown inertial navigation system is simulated by MATLAB, and the simulation data of angular velocity and acceleration are obtained.
This simulation can be used as a reference routine for course learning and basic routine for writing journal papers_ Model. M "is the main program, and each sub module is annotated.)
- 2020-12-15 17:50:57下载
- 积分：1
-
mfile
数字大房间混响程序，根据Gardener模型所写，22k和44.1k滤波器参数已存储为matlab数据文件可直接用(The reverberation procedure of digital large room is written according to Gardener model.)
- 2018-06-07 11:11:15下载
- 积分：1
-
20180620_LPF
Low-pass filter design method, teach you how to use it in MATLAB
- 2019-02-22 15:31:20下载
- 积分：1
-
LLC_VCO_COSELOOP_V1
说明： VCO电路，PSIM模型，有需要请使用。(Voltage Control Oscillator PSIM module)
- 2021-01-31 11:18:32下载
- 积分：1
-
jihejianmo
说明： 点云几何建模，根据树干模拟圆柱。采用的算法是最小二乘拟合圆，得出各段圆心坐标，在根据各段半径，模拟出圆柱(Point cloud geometric modeling, according to the trunk simulation cylinder. The algorithm used is the least square fitting circle to get the coordinates of the center of each section. According to the radius of each section, the cylinder is simulated)
- 2020-05-06 10:29:34下载
- 积分：1
-
上机5 梁枫 崔展
一、实验目的
通过本实验，了解信号估计的最小二乘法原理。
二、实验要求
1．导入受噪声污染的高斯信号数据，并绘制该信号。
2．推导高斯信号最小二乘法估计公式。
3．利用估计公式估计高斯信号的参数（幅值、均值和方程）。
4．画出估计出的高斯信号。(First, the purpose of the experiment Through this experiment, we know the least square method of signal estimation. Two. Experimental requirements 1. import noise contaminated Gauss signal data and draw the signal. 2. derivation of Gauss signal least squares estimation formula. 3. estimate the parameters of the Gauss signal (amplitude, mean and equation) by using the estimation formula. 4. draw the estimated Gauss signal.)
- 2018-06-24 17:00:54下载
- 积分：1
-
数字电路故障分析之D算法C++实现。按照教科书编写，可能比较古板。...
数字电路故障分析之D算法C++实现。按照教科书编写，可能比较古板。-digital circuit failure analysis algorithm C D realization. According to textbook writing, perhaps more rigid.
- 2022-07-27 11:48:22下载
- 积分：1
