登录
首页 » matlab » 基于simulink的步进电机细分驱动

基于simulink的步进电机细分驱动

于 2019-05-07 发布
0 239
下载积分: 1 下载次数: 27

代码说明:

说明:  基于simulink的步进电机细分驱动,可以实现四细分电流,使得步进电机稳定运行(Design of Stepping Motor Current Subdivision Drive Based on Simlink)

文件列表:

xifensanjiaobo.slx, 28499 , 2019-04-22

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 基于TMS320F28335的MODBUS-RTU从站
    基于TMS320F28335的MODBUS-RTU从站程序(MODBUS-RTU slave program based on TMS320F28335)
    2021-04-21 14:48:49下载
    积分:1
  • 一种数码照片降噪的方法
    一个很实用的数码照片降噪的方法,matlab编的,相信对很多图像处理的人都有帮助(A photo process method for noise reduction, written by matlab.)
    2005-07-19 17:59:46下载
    积分:1
  • 28335_program
    DSP 28335 APF 功能 测试过的(DSP 28335 APF function after tested)
    2014-09-07 16:56:11下载
    积分:1
  • exm3_1_1mdl
    这是用Matlab自己搭建的直驱式风力发电并网逆变器的仿真模型,效果挺不错的。-It is built using Matlab own direct drive wind power inverter with the simulation model, the effect is very good.(This is a simulation model with a the Matlab build their own direct-drive wind power generation, grid-connected inverter, the effect is very good.-It is built using Matlab own direct drive wind power inverter with the simulation model, the effect is very good.)
    2012-11-05 15:46:41下载
    积分:1
  • Main_boost_i
    实现boost电流和电压的迭代映射函数程序,可操作性较高(An iterative mapping function program to realize boost current and voltage is highly operable)
    2017-11-29 09:45:42下载
    积分:1
  • NHET_as_GIO
    TMS570 NHET模块用作gio示例程序 基于ccs v4环境(TMS570 NHET modules for gio sample application environment based on ccs v4)
    2011-11-01 01:35:36下载
    积分:1
  • 演示
    说明:  设计了跳频通信系统 产生了跳频信号 研究了 短时傅里叶变换 Gabor变换 基于时频稀疏性的方法对跳频信号进行研究(Output pseudo-random sequence Output frequency hopping signal time domain waveform Draw the time-frequency diagram of fH signal with several different time-frequency analysis methods The variation curve of the accuracy of fH periodic estimation with SNR under different output frequency analysis method)
    2021-03-09 15:59:28下载
    积分:1
  • c5510_vector
    TI公司DSP C5510的中断向量表文件(TI)
    2008-05-20 19:38:14下载
    积分:1
  • 该工实现对单载波系统QPSK的频偏估计算法 freq_estimate
    该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波,而发射机和接收机之间往往存在频率偏差,为了消除这种误差,必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计,经验证,效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)
    2020-06-27 04:40:01下载
    积分:1
  • 波束形成
    波束形成算法是智能天线研究中最核心的内容。波束形成算法根据基于的对象不同可以分为基于方向估计的自适应算法,基于训练信号或者参考信号的方法和基于信号结构的波束形成方法;根据是否需要发射参考信号,分为非盲算法和盲算法。(The beamforming algorithm is the most important content in the research of smart antenna. Based on the beamforming algorithm according to the different objects can be divided into adaptive algorithm based on direction estimation method based on a training signal, or reference signal and signal beam forming method based on structure; according to whether to send the reference signal, divided into non blind algorithms and blind algorithms.)
    2017-12-26 15:29:38下载
    积分:1
  • 696516资源总数
  • 106415会员总数
  • 3今日下载