-
MAX291
max291，成控滤波器芯片，代码加电路加资料(max291·····················)
- 2010-06-20 12:51:31下载
- 积分：1
-
STM32TFT-DA
stm32f103zet6 KEIL MDK 包括功能 3.5寸TFT彩屏 fsmc接口通讯；
电阻触摸 xpt2046 采用SPI通讯 AD数据采集 DMA传输 2000点，以及平滑滤波；DA输出；
(Stm32f103zet6 including 3.5-inch TFT color screen fsmc interface communication
Resistive touch xpt2046 using SPI communication AD data acquisition DMA transfer 2000 points, and smoothing filter DA output )
- 2017-05-03 23:30:53下载
- 积分：1
-
NRF24L01
NRF24L01+模块发射程序，80c52程序，有经过调试(Module launch program)
- 2014-02-27 21:07:12下载
- 积分：1
-
mcu8051
单片机C语言程序设计实训100例——基于8051+Proteus仿真(Microcontroller C Programming Language Training 100 cases- based 8051+Proteus simulation)
- 2012-11-19 10:01:45下载
- 积分：1
-
WK2124SPI(MCU_VK8001)
WK2124 SPI MCU VK8001
- 2020-06-19 23:00:02下载
- 积分：1
-
DS18B20peratureConversionSubroutine
DS18B20芯片的温度转换子程序精度为0.5(Temperature Conversion Subroutine)
- 2009-04-07 18:11:15下载
- 积分：1
-
PowerManage
一个很好的 电源管理程序 很不错哦 能定时管理你的电池(A very good power management process, oh well you can manage the battery from time to time)
- 2009-05-22 17:40:39下载
- 积分：1
-
_Cargador
硬件电路比较简单，3个LED指示灯，5个按键控制上下左右及暂停，LCD显示。总共有20关。设计用到了逻辑门控制电路。(The hardware circuit is simple, 3 LED lights, 5 key control above and below and suspension, LCD display. A total of 20 customs. The design used in the logic gate control circuit.
)
- 2011-12-23 10:36:21下载
- 积分：1
-
12864
stm32 的12860串行程序 只需要两根数据线就能用stm32驱动12864 节省了io(the stm32 12860 serial program only two data lines will be able to stm32 drive save the io 12864)
- 2012-07-01 13:44:23下载
- 积分：1
-
pedometer
本文设计了基于加速度传感器的计步器，并通过仿真以及实际调试得到了相应的结果的记录。本实验首先通过加速度传感器检测目标物体的运动，产生脉冲，将脉冲放大后经过施密特触发器整型为方波，并给出了方波的调试电路图。然后编写程序，利用D触发器检测方波的上升沿，当上升沿到来时，计数，并对十位、个位分别编码，然后由使能信号交替控制数码管输出结果。本文给出了仿真以及调试的程序、结果。(This article is designed pedometer-based acceleration sensor and the corresponding results recorded by simulation and debugging. The experiments by first acceleration sensor detects the movement of the target object, generates a pulse, the pulse amplification is a square wave after the Schmitt trigger integer, and gives the the debug circuit diagram of a square wave. Then write procedures, the use of the rising edge of the detection of the square wave of the D flip-flop, when the rising edge, the count, and ten bits are encoded, and then alternately by the enable signal output of the digital control. In this paper, a simulation and debugging procedures, results.)
- 2013-03-13 08:58:22下载
- 积分：1
