登录
首页 » matlab » 时间转换

时间转换

于 2021-04-06 发布
0 804
下载积分: 1 下载次数: 9

代码说明:

说明:  一般时与儒略时以及GPS周、秒的相互转换(Conversion between general time and Julian time and GPS cycles and seconds)

文件列表:

时间转换, 0 , 2019-03-16
时间转换\date2gpst.m, 71 , 2019-03-16
时间转换\date2mjd.m, 233 , 2019-03-16
时间转换\gpst2date.m, 71 , 2019-03-16
时间转换\gpst2mjd.m, 97 , 2019-03-16
时间转换\mjd2date.m, 220 , 2019-03-13
时间转换\mjd2gpst.m, 141 , 2019-03-13

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • efd65e66cab2
    说明:  在matlab中用yalmip建模cplex求解双目标线性规划的编程案例(Using yalmip to model CPLEX to solve the programming case of Bi objective linear programming in MATLAB)
    2020-12-18 08:09:13下载
    积分:1
  • zerosum
    用于零和博弈的算法程序,直接用,拿走不谢(For the zero - sum game algorithm procedures, directly used by)
    2020-11-17 11:09:40下载
    积分:1
  • patterns1
    本程序可以在确定初值的情况下,计算已知非线性系统的平衡点,并作出斑图模拟(This program can calculate the equilibrium point of a known nonlinear system and make a pattern simulation when the initial value is determined.)
    2019-03-19 16:41:32下载
    积分:1
  • 说明:  1、基带码型仿真 (1)通过仿真观察占空比为50%、 75%以及100%的单、 双极性归零码波形以及其功率谱,分析不同占空比对 仿真结果的影响。 (2) 通过仿真产生一随机消息码序列,将其分别转换为 AMI码和HDB3码,观察它们的波形及其功率谱密度。 2、数字带通调制系统仿真 设计一个采用2ASK( OOK) 调制的数字通信系统: 产生二进制随机数据,并仿真其对应的2ASK调制波形, 分析其频谱。所产生的调制波形加入不同信噪比的白噪声, 选取合适的接收方案,画出系统误码率曲线,并与理论误 码率进行对比。(1.Baseband pattern simulation 2. Simulation of digital band-pass modulation system)
    2020-06-29 07:20:01下载
    积分:1
  • OFDM
    说明:  OFDM系统仿真,分析了AWGN信道和瑞利衰落信道下的ber曲线(The simulation of OFDM system analyzes the BER curves of AWGN channel and Rayleigh fading channel)
    2020-05-22 10:21:03下载
    积分:1
  • baoluo
    说明:  对信号进行傅里叶频谱求解,同时进行包络谱的结算(The signal is solved by Fourier spectrum, and the envelope spectrum is settled at the same time)
    2021-04-15 19:49:08下载
    积分:1
  • GPS_acq
    GPS信号的捕获.GPS信号处理中CA码捕获的Matlab程序,CA码的产生,GPS信号产生(c/a generation GPS signal acquisition)
    2020-11-28 20:09:29下载
    积分:1
  • SVM
    三相SVPWMmatlab仿真模型,需要提醒同志们的是,在仿真之前必须build一下s-function builder,不然无法运行模块,采用s-builder的原因是建成的模块很简洁,而且运行速度要比其他方法快的多(The three-phase SVPWMmatlab simulation model, the need to remind Comrades is, before the simulation must be build S-function builder, or can not be run by s-builder module, the reason is built module is very simple, and the speed is much faster than other methods)
    2017-11-02 17:19:03下载
    积分:1
  • 蚁群算法+Dijkstra算法=二维路径规划
    蚁群算法+Dijkstra算法=二维路径规划(Ant colony algorithm+Dijkstra algorithm-two-dimensional path planning)
    2021-04-26 16:38:45下载
    积分:1
  • ambiguity_function
    模糊图函数,输出信号的模糊图,输入量为两个(信号,归一化)(Ambiguity Function)
    2010-01-23 16:37:46下载
    积分:1
  • 696518资源总数
  • 105885会员总数
  • 31今日下载