登录
首页 » matlab » abqus车桥耦合命令流

abqus车桥耦合命令流

于 2020-05-09 发布
0 150
下载积分: 1 下载次数: 6

代码说明:

说明:  matlab车桥耦合,计算分析,便于自学(Matlab vehicle bridge coupling)

文件列表:

abqus车桥耦合命令流, 0 , 2018-10-11
abqus车桥耦合命令流\j1(1).rar, 34493 , 2018-10-11
abqus车桥耦合命令流\j1.inp, 126167 , 2010-06-27
abqus车桥耦合命令流\j1.rar, 34493 , 2018-10-11
abqus车桥耦合命令流\KS.png, 13076 , 2018-10-11

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • junhenghua
    关于图像的均衡化,绘制图像的灰度直方图,得到均衡化以后的图像(Equalization on the image and draw the image histogram, image obtained after equalization)
    2010-07-06 16:37:29下载
    积分:1
  • TT
    说明:  The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:46:57下载
    积分:1
  • Matlab-fdtd
    Matlab fdtd (时域有限差分)一维,二维,三维集合(Matlab fdtd (FDTD) one-dimensional, two-dimensional, three-dimensional collection)
    2013-01-31 11:23:34下载
    积分:1
  • EnergyDetection
    Energey Detection ROC plot. Probablity of detection vs Probablity of false alarm.
    2015-04-01 17:01:27下载
    积分:1
  • inverse_st
    S变换的逆变换源程序,用于matlab环境下。.t的格式(The S transform inverse transform source code for the Matlab environment. Format. T)
    2013-05-18 01:51:40下载
    积分:1
  • 雷达信号处理基本流
    去斜处理(宽带的匹配滤波)Stretch方法是针对线性调频信号而提出的, 其方法是将输入信号与参考信号 (经适当延迟的本振信号, 延迟量通常由窄带信号测距结果估计出) 混频 ,则每一个散射点就对应一个混频后的单频分量,对混频输出的信号进行 DFT 处理 ,即可获得目标的距离像,对参考信号的要求是应具有与输入信号相同的调频斜率。(dechirp matched filter Stretch method is proposed for linear frequency modulation signal. It mixes the input signal with the reference signal (local oscillator signal with appropriate delay, the delay is usually estimated from the result of narrowband signal ranging). Then each scattering point corresponds to a single frequency component after mixing, and DFT is performed on the mixed-frequency output signal. The range profile of the target can be obtained by processing, and the reference signal is required to have the same frequency modulation slope as the input signal.)
    2018-10-31 20:07:27下载
    积分:1
  • 5-27-CLT
    Central Limit Theorem CLT Example Normal Approximation to the Binomial
    2010-07-19 13:23:30下载
    积分:1
  • Threshold
    Determining threshold for testing z(n)=N(n) against z(n)=a+N(n) where all of parameters are known
    2010-08-18 00:11:02下载
    积分:1
  • Paper-1
    this is a very interesting paper, ple read it PerformanceofAlamoutiSchemewith TransmitAntennaSelectionfor M-raySignals
    2012-11-16 11:01:53下载
    积分:1
  • EE-550-Asgn3-Q5
    matlab file for linear control system assgnment proeblem
    2015-04-17 22:33:25下载
    积分:1
  • 696518资源总数
  • 106215会员总数
  • 5今日下载