登录
首页 » PDF » J1939Seminar

J1939Seminar

于 2009-04-07 发布 文件大小:1764KB
0 169
下载积分: 1 下载次数: 44

代码说明:

  J1939 Basic Seminar doc

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • ChauYuen
    说明:  Chau Yuen的酉空时码例程, 瑞利衰落信道下,采用4发1收,比较了不同信噪比下的BER和SER(Chau Yuen Unitary space-time code routines, Rayleigh fading channel, using 4-fat one collection, comparison of different signal to noise ratio of BER and SER)
    2008-09-23 19:47:48下载
    积分:1
  • findpks_MinMax
    Find peaks in signal. Look for local maxima and minima. In the window of search find the maximum maxima and the minimum minuma. Return two values which are the maximum and the minimum local maximas
    2010-06-18 00:46:33下载
    积分:1
  • signal_seg
    利用独立分量分析方法对三个信号进行分离,入门学习(The use of independent component analysis method to separate the three signals, Introduction to learning)
    2009-04-15 11:37:10下载
    积分:1
  • Mtlabprograms
    说明:  四维超混沌系统,平衡点 图像,李雅普诺夫指数,完全同步(Four-dimensional hyperchaotic system, balance the image, Lyapunov exponent, fully synchronized)
    2011-04-04 00:03:24下载
    积分:1
  • Codes
    this code is for Object Co-Segmentation Based on Shortest Path Algorithm and Saliency Model paper. I used this code and it was correct and make true answers.
    2014-08-14 14:56:43下载
    积分:1
  • mseq-modulation
    基于m序列的DS-CDMA通信系统仿真的调制解调模型(M-sequence-based DS-CDMA communication system simulation model of modulation and demodulation)
    2013-08-25 20:45:26下载
    积分:1
  • windfarm_synmc-psl
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:52:32下载
    积分:1
  • series
    仿真了6种序列,包括原序列,以及fft的结果,对比了不同N值对于fft结果的影响(Six sequence simulation, including the original sequence, and the fft results, comparing the different N values ​ ​ for fft results of)
    2011-11-13 09:30:37下载
    积分:1
  • 1466
    matlab simulink implementation and analysis of Three-phase inverter
    2013-11-30 22:49:22下载
    积分:1
  • 251715220842756
    说明:  蓄电池充放电simulink模型,基于三阶模型的铅酸蓄电池建模与仿真_纪伯公(Simulink model for charging and discharging of storage battery)
    2021-01-29 22:08:34下载
    积分:1
  • 696518资源总数
  • 105873会员总数
  • 12今日下载