-
mexDDGrab
matlab 可以调用的动态视频代码；matlab 可调用的动态视频代码；matlab 可以调用的动态视频代码(matlab for video dll；matlab for video dll；matlab for video dll)
- 2012-03-24 10:47:38下载
- 积分：1
-
MATLABfacefbtprotected
Face Recognition Based on Polar Frequency Features
- 2012-05-25 17:37:06下载
- 积分：1
-
OFDM_QPSK-16QAM-64QAM
OFDM编码,调制的方法有QPSK,16QAM和64QAM(OFDM coding, modulation method QPSK, 16QAM and 64QAM)
- 2014-02-03 21:57:22下载
- 积分：1
-
VCmatlabmfile
VC调用matlab中定义的.m文件中的函数的实例(vc use matlab m-file )
- 2010-07-24 13:15:34下载
- 积分：1
-
ofdm_simulation
说明： 该源码可以实现OFDM系统的比特加载和功率分配算法的仿真(The source code can be bit-loaded OFDM system and Power Allocation Algorithm for Simulation)
- 2008-11-06 19:02:02下载
- 积分：1
-
Rapid-Acquisition-of-Doppler-Shift-
本文提出了一种适用于低轨卫异扩频通信系统的多普勒频移快捕方法.该方法基于数字匹配滤波器及自动频率控制环路_利用数字匹配滤波器的囚码快捕特性及其输出主相关峰值对频偏的敏感性，缩短多普勒频移的
捕获时间.论文首先推导了多普勒频移的平均捕获时间表达式，然后根据数值分析结果得到了准最佳捕获判决策略，最后通过比较验证了该快捕方法相对于传统串行捕获方法在性能上的提高.
(This paper presents a low-orbit health for different spread spectrum communication system fast catching the Doppler shift method, which based on digital matched filter and automatic frequency control loop _ prisoners using digital matched filter code features rapid acquisition and the output of the main correlation peak frequency deviation of the sensitivity of the Doppler frequency shift to shorten acquisition time. paper first derive the mean Doppler shift acquisition time expression, then the numerical results obtained quasi-optimal capture decision strategies, and finally verified by comparing with the rapid acquisition method to capture the traditional method of serial improvement in performance.)
- 2011-10-22 19:35:00下载
- 积分：1
-
sw_pretrigger
This m-file implements a simple data acquisition gui with multiple channels and custom triggering
It demonstrates how to:
1) Use nested functions to simplify data acquisition programs
2) Use a simple GUI (a couple of pushbuttons) to start and stop data acquisition.
3) Wait for an event/trigger (like a button press) and log pre-event or pre-trigger data from multiple synchronized channels.
4) Record pretrigger data based on custom criteria. In this m-file the triggering event is a button click. However, the event could be any custom criterion (e.g., the data amplitude is greater than a threshold *and* a toggle button is enabled).
Requires: the Data Acquisition Toolbox (TM) and the Winsound adapter. It does not depend on any hardware-specific capabilities. (This m-file implements a simple data acquisition gui with multiple channels and custom triggering
It demonstrates how to:
1) Use nested functions to simplify data acquisition programs
2) Use a simple GUI (a couple of pushbuttons) to start and stop data acquisition.
3) Wait for an event/trigger (like a button press) and log pre-event or pre-trigger data from multiple synchronized channels.
4) Record pretrigger data based on custom criteria. In this m-file the triggering event is a button click. However, the event could be any custom criterion (e.g., the data amplitude is greater than a threshold*and* a toggle button is enabled).
Requires: the Data Acquisition Toolbox (TM) and the Winsound adapter. It does not depend on any hardware-specific capabilities. )
- 2009-10-21 15:18:03下载
- 积分：1
-
ndfa-1.0.tar
这是从国外网站下载的Nonlinear dynamical factor analysis Matlab 源代码(This is the website from outside of the Nonlinear dynamical factor analysis Matlab source code)
- 2009-12-16 21:04:44下载
- 积分：1
-
fsdhejijidhouyufashe
低频信号先进行放大，再调制解调，设计发射机和接收机(Low-frequency signal is first amplified, and then modulation and demodulation, the transmitter and receiver design)
- 2013-11-28 10:03:15下载
- 积分：1
-
dpd_simulation
功放数字预失真算法代码，用Volterra模型对功放建模，Ls算法(Power amplifier digital predistortion algorithm code, using the on the model of power amplifier modeling, Ls algorithm
)
- 2021-01-06 16:38:53下载
- 积分：1
