-
CA_CFAR
仿真了恒虚警的平均单元算法，给出仿真结果，同时分析了不同窗口数对虚警率和检测率的影响，并写了详细的注释(The constant false alarm average cell algorithm is simulated, and the simulation results are given. Meanwhile, the influence of different window numbers on false alarm rate and detection rate is analyzed, and detailed annotations are written.)
- 2017-12-05 13:36:59下载
- 积分：1
-
PcmTesting
这是一个将语音信号通过PCM编码传输的仿真测试程序，内有详细注释，希望对大家有用。(This is a voice signal transmission through the PCM coded simulation testing procedures, with detailed notes, We hope that the right useful.)
- 2007-03-14 22:17:36下载
- 积分：1
-
802p11TGn_ChannelModel
这是一个关于ofdm在802.11协议下的源码，很有参考价值，希望对大家有用(This is a matter of OFDM in the 802.11 protocol under the source, a good reference, in the hope that useful)
- 2021-03-18 20:39:20下载
- 积分：1
-
ECE 4634
说明： Zero forcing - with interference cancellation
- 2019-04-27 21:44:17下载
- 积分：1
-
LDPC-coded-OFDM-for-PLC
LDPC coded OFDM system for power line communication in the presence of both AWGN and Impulsive noise..
- 2020-10-12 11:17:32下载
- 积分：1
-
ANSYS里的数据导入MATLAB
ANSYS里的数据导入MATLAB，用于ANSYS与MATLAB交换数据。(The data in ANSYS is imported into MATLAB)
- 2018-04-02 21:28:20下载
- 积分：1
-
499503
turbo码的matlab仿真源程序,比较详细,包你满意()
- 2018-04-17 17:43:21下载
- 积分：1
-
PPPOEchangjianguzhangdaima
pppoe常见故障分析,电信故障排除所需要的PPPOE知识(pppoe common fault analysis, telecommunications, troubleshooting knowledge required for PPPOE)
- 2009-09-16 17:13:05下载
- 积分：1
-
cordic
实现可连续输入数据做三角函数变换处理，通过verilog代码实现，(It realizes triangular function transformation for continuous input data.)
- 2020-06-21 22:40:01下载
- 积分：1
-
BPSK调制仿真
说明： bpsk调制仿真，可直接用
1、数字调制方法
数字调制就是把数字基带信号的频谱搬移到高频处，形成适合在信道中传输的带通信号。基本的数字调制方式有振幅键控（ASK）、频移键控（FSK）、绝对相移键控（PSK）、相对（差分）相移键控（DPSK）。在接收端可以采用想干解调或非相干解调还原数字基带信号。
数字信号的传输方式分为基带传输和带通传输。然而，实际中的大多数信道（如）无线信道具有丰富的低频分量。为了使数字信号在带通信道中传输，必须用数字基带信号对载波进行调制，以使信号与信道的特性相匹配。(1, digital modulation method
Digital modulation is the transfer of the spectrum of a digital baseband signal to a high frequency to form a bandpass signal suitable for transmission in the channel. The basic digital modulation methods are amplitude keying (ASK), frequency shift keying (FSK), absolute phase shift keying (PSK), and relative (differential) phase shift keying (DPSK). At the receiving end, the digital baseband signal can be restored by using dry demodulation or non-coherent demodulation.
Digital signal transmission methods are divided into baseband transmission and bandpass transmission. However, most channels in practice, such as wireless channels, have rich low frequency components. In order for a digital signal to be transmitted in a band channel, the carrier must be modulated with a digital baseband signal to match the signal to the characteristics of the channel.)
- 2019-05-28 10:46:01下载
- 积分：1
