-
xunijilifa
虚拟激励法的实现，4自由度的随机振动问题，包含详细说明，对出学者有很好启示作用！(The realization of the virtual excitation method, 4 degrees of freedom random vibration problems, including details of the scholars have a good inspiration!)
- 2010-11-28 10:13:05下载
- 积分：1
-
OFDM_signal
Orthogonal Freq, Division signal
- 2013-07-10 18:55:44下载
- 积分：1
-
gaossal
大地测量学高斯正反算，matlab的gui界面写成的(The geodetic gaussian is positive and negative, matlab GUI interface of written
)
- 2011-12-27 00:16:24下载
- 积分：1
-
hpmodelwithoutcontroller
this is a matlab model of single machine infinite bus with out any controller. we can add any type of controller for verification of stability of the system
- 2014-01-08 13:43:56下载
- 积分：1
-
music
在程序中用一般的MUSIC方法估计了信号的频谱，从两图中可看出在信号各频率处，频谱的峰值较大，故能明显的与噪声相区别，可在一定程度上避免在信号幅度较小时信号被噪声淹没的情况。(MUSIC method general procedures used to estimate the spectrum of the signal, it can be seen from the two graphs in the signal at each frequency of the spectrum peak larger, and it could be significantly distinguished from noise in the signal can be avoided to some extent a lesser extent, the signal is noise submerged.)
- 2013-01-06 21:36:41下载
- 积分：1
-
ThrSample2
自然三次样条几乎等同于样条设备生成的曲线。在这些所有的二次连续可导函数中，钳位与自然三次样条可以得到相对于待插值函数 f 的最小值(spline interpolation)
- 2012-04-26 21:59:27下载
- 积分：1
-
PLFhybridmethod
大气湍流中，关于亚谐波的产生方法有三种，此程序为用LANE的方法产生(Atmospheric turbulence, with regard to sub-harmonic generation in three ways, the program is produced by a method LANE)
- 2015-05-18 17:29:13下载
- 积分：1
-
大尺度和小尺度衰落信道的模拟xindaomoniqi
改程序实现了大尺度和小尺度衰落信道的模拟，可以通过改变载波、通信距离、阴影衰落标准差来观察信道容量的变化。(Change the program to achieve a large-scale and small-scale fading channel simulation, you can change the carrier, communication distance, shadow fading standard deviation to observe the changes in channel capacity.)
- 2020-07-19 12:48:47下载
- 积分：1
-
fuzzycode
fuzzy code with matlab
- 2010-07-09 13:19:46下载
- 积分：1
-
Simple_TOA
This is a simple position location algorithm using Least Square Estimation algorithm. Timing information is time of flight (TOA) of signal between Tx and Rx. This code generally describes the Positioning method, Also it plots final coordinate of node in 2D. All other information was inlcuded as comments in source code.
- 2009-06-16 13:01:12下载
- 积分：1
