-
functionmod
由信道信号的复数值解调对应的二进制序列由信道信号的复数值找出对应的二进制序列。方法如下：由信道值，
％％求出该值与星座图中所有点的距离，找出距离最小的点，该点对应的
％％二进制序列及为该信道对应的解调结果。
(Channel signal by the complex demodulation value corresponding to the binary sequence by the complex channel signals to identify the corresponding binary numerical sequence. As follows: by the channel value, the value obtained with the constellation diagram of all points of distance, find the smallest distance between points, the points of the corresponding binary sequence and the corresponding channel demodulation results.)
- 2008-04-28 10:18:55下载
- 积分：1
-
ANN
基于神经网络的强机动目标跟踪，可以自适应调节机动频率。(Strong based on neural networks maneuvering target tracking, can adaptively adjust maneuvering frequency.)
- 2013-11-16 18:03:25下载
- 积分：1
-
svpwm3
基于matlab的异步电动机仿真控制，控制方式为svpwm波，输出结果理想。(Based on simulation matlab induction motor control, control of svpwm wave output ideal.)
- 2013-11-25 10:09:55下载
- 积分：1
-
cc
<<现代信号处理教程>>(胡广书版)书中配套的matlab源代码。(this is a matlab code of the book called modem signal processing.)
- 2013-08-18 10:31:03下载
- 积分：1
-
基于DWT的数字水印的嵌入与提取
说明： 基于小波变换的数字水印，包含的嵌入与提取代码，原理等(Digital watermarking based on wavelet transform, including embedded and extracted code, principle, etc)
- 2021-02-07 18:29:55下载
- 积分：1
-
mcmc71
monte carlo 算法 Denoising of letter A: Ising Prior(monte carlo algorithm Denoising of letter A: Ising Prior)
- 2011-10-25 11:04:13下载
- 积分：1
-
power_3phsignaldq
3 phase signals converted to d-q signals with graphs of both
- 2009-04-01 18:41:18下载
- 积分：1
-
ChiLunJiSuan
这是一个关于齿轮的齿顶圆和齿根圆半径的计算程序，先将图片预处理和二值化，然后进行边缘检测求出圆心，最后用平均法求出半径。(This is an addendum on the gear tooth root radius circle and the calculation procedure, the first image preprocessing and binarization, edge detection and then find the center of a circle, with the final calculated average radius.)
- 2010-12-13 15:17:28下载
- 积分：1
-
ACATSP
It s a word document,matlab code,basic algorithm of ant colony.(It's a word document, Matlab code, basic algorithm of ant colony.)
- 2007-01-10 11:37:19下载
- 积分：1
-
Runge_Kutta
此程序是有关用四阶龙格库塔法计算微分方程的程序。(This program is the fourth-order Runge-Kutta method to calculate the differential equations of the program.)
- 2011-12-20 16:34:40下载
- 积分：1
|
联系客服（QQ：3324461878）
