-
Blind_Signal_Separation_instantaneous_mixing_the_a
盲信号分离(BSS)是指在对彼此独立的源信号混合过程及各源信号本身均未知的情况下，从混合信号中分离出这些源信号的方法。BSS可以用来从多个麦克风混合语音信号中提炼出单个语音信号。本文简要阐述LMS、RLS算法，并通过仿真实验来分析比较这两类方法的性能，并利用此方法对一实际的语音信号进行分离。(Blind Signal Separation (BSS) is defined as independent of each other mixed-signal process and the source of the signal itself are unknown circumstances, from the mixed-signal to isolate the source of these signals. BSS can be used from multiple microphones mixed voice signal to extract a single speech signal. This paper briefly described LMS, RLS algorithm, and through simulation experiments to analyze the comparative performance of these two types of methods and take advantage of this method on a real speech signal separation.)
- 2008-04-13 17:58:33下载
- 积分：1
-
delphi2
delphi与matlab混合编程研究 (delphi with matlab Mixed Programming)
- 2011-02-06 21:57:12下载
- 积分：1
-
learnning03
使用matlab语言设计的，跳频扩频通信系统仿真程序。(use Matlab language design, frequency hopping spread spectrum communication system simulation program.)
- 2006-07-24 16:16:07下载
- 积分：1
-
VANET-simulations
V2V simulation vehicle to vehicle communication(vehicle to vehicle communication based on random sourcing, urban & highway situation)
- 2013-10-01 20:11:26下载
- 积分：1
-
基于最大信噪比的盲源分离算法
基于最大信噪比的盲源分离算法，有论文和程序。(A blind source separation algorithm based on maximum signal-to-noise ratio (SNR) is presented.)
- 2017-10-11 18:48:30下载
- 积分：1
-
kalman
GPS 导航定位系统卡尔曼滤波
假定船舶向某固定方向航行，以港口码头的出发处为坐标原点。
假定船舶在二维平面上运动，初始位置为（-100m，200m），水平运动速度为 2m/s，
垂直方向运动速度为 20m/s，GPS 接收机的扫描周期为 T = 1s，观测噪声的均值
为 1，方差为 100。
采用卡尔曼滤波跟踪船舶航行轨迹。
1、绘出真实轨迹、观测轨迹、滤波后轨迹
2、滤波前误差、滤波后误差(Calman filtering of GPS navigation and positioning system)
- 2020-06-26 16:40:01下载
- 积分：1
-
randgen2
randgen(mu,mu1,mu2,cov1,cov2,cov3) = Random generation of Gaussian Samples
in d-dimensions where d = 2
mu, mu1, mu2 = (x,y) coordinates(means) that the gaussian samples are centered around
cov1, cov2, cov3 are the covariance matrices and will vary changing the
shape of the distribution, example: cov = sigma^2*Identity Matrix, where sigma^2 = a scalar
N = the number of gaussian samples used are provided as user input,
A test set of N/2 and a training set of N/2 gaussian samples is also generated
Output is directed to the command window and a plot of the distributions are generated
- 2011-02-09 18:52:20下载
- 积分：1
-
Alamouti2tx1rx
aloumouti stbc 2tx -1rx
- 2010-04-24 10:54:32下载
- 积分：1
-
System-ID-optimal-control
研究生课程系统辨识与最优控制课后习题编程源代码，在matlab07b上调试通过(Graduate courses System Identification and Optimal Control Homework programming source code, debugging through on matlab07b)
- 2012-09-26 20:37:12下载
- 积分：1
-
Mote_Carlo_snr_ber
蒙特卡洛法对2psk,2fsk通信系统进行仿真，计算不同信噪比(SNR)条件下的误码率（BER）并画图(2PSK,2FSK communication system simulation using Monte Carlo method in MATLAB, calculating the different BERs for different SNRs and plot figures.)
- 2014-07-04 13:49:22下载
- 积分：1
