登录
首页 » Matlab » 霍夫变换检测高速公路车道线

霍夫变换检测高速公路车道线

于 2022-06-01 发布 文件大小:307.57 kB
0 121
下载积分: 2 下载次数: 3

代码说明:

霍夫变换检测高速公路的直线车道线,首先给出阈值得到车道线的边缘图像,然后用霍夫变换检测出车道线,最终显示在原始的车道线图片上

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MTALABandsimulink
    用四阶龙格库塔法求非线性系统的输入相应,同时用simulink建模比较。 (Using fourth-order Runge-Kutta method for the corresponding input nonlinear systems, and modeling using simulink comparison.)
    2009-03-28 14:20:09下载
    积分:1
  • walshtransform
    说明:  walshl变换的定义的原代码(m)及说明文件(txt)。(the instruction(.txt) and defination(.m) of walsh transform )
    2011-03-22 15:37:16下载
    积分:1
  • teager
    说明:  teager能量算子MATLAB代码,应用于信号分析(Teager Energy Operator MATLAB Code)
    2019-01-26 15:20:54下载
    积分:1
  • KPCA
    基于KPCA(核主元分析)发对TE模型进行故障诊断和辨识(Based on KPCA (KPCA) TE model made of fault diagnosis and identification)
    2009-06-30 19:46:34下载
    积分:1
  • four
    计算成组滑动的滑窗检测器的最佳门限已知: 击中数N = 128, 组宽n = 8,PF = 10¡ 6,PD = 90 假设以下条件: (a) 信号不起伏 (b) 忽略天线波束调制 1 (c) 计算PD时忽略目标区以外噪声的影响 组门限(第二门限)为K=8 滑窗的门限(第三门限)为L=16 (滑窗中包含的组数为16) 求解: 最佳的KOPT 和LOPT,对这题做了具体仿真实现。需要的朋友,一定知道很有用。(Optimal threshold calculated as group slidable window detector is known: hit number N = 128, the group width n = 8, PF = 106, PD = 90 assuming the following conditions: (a) signal is not undulation ( b) ignore the antenna beam modulation 1 (c) the calculation of PD ignored outside the target area noise of impact group door limit (the second door limit) for K = 8 sliding window of the door limit (third door limit) for L = 16 (sliding window contains group 16) to solve: the best of the KOPT the LOPT, these questions do specific simulation to achieve. A friend in need, we must know to be useful.)
    2012-10-18 11:02:12下载
    积分:1
  • Untitled
    关于线性调频信号,输出它的时域、幅度谱、相位谱(Linear FM signal, the output of its time-domain amplitude spectrum and phase spectrum)
    2021-03-09 08:29:27下载
    积分:1
  • rbf1
    此源代码是用MATLAB训练RBF网络,用的是数据中心聚类法,算法中没有用MATLAB中的训练函数(This source code is used MATLAB training RBF networks, data centers are using a clustering method, the algorithm does not use the training function in MATLAB)
    2008-03-10 09:49:02下载
    积分:1
  • Plotter-1_0
    将示波器CSV文件在MATLAB中画成图形,并进行FFT(input the .csv file of scope into matlab)
    2012-04-03 15:18:22下载
    积分:1
  • CtoF
    Converter Celsius Fahrenheit for a temperature set by the user
    2010-05-25 05:56:57下载
    积分:1
  • LDPC--MA
    介绍了ldpc码的发展概况,历程,各种编解码算法,对初学者有很大帮助(Describes the overview of the development ldpc code, course, a variety of codec algorithm, very helpful for beginners)
    2013-09-22 19:31:06下载
    积分:1
  • 696518资源总数
  • 106227会员总数
  • 11今日下载