-
matlab
在MATLAB中写M文件：要求用三重循环求两矩阵相乘(M file in MATLAB, write: Request to use triple-loop order to multiply two matrices)
- 2009-10-23 19:27:35下载
- 积分：1
-
8259.asm
直接用手动产生单脉冲作为中断请求信号。 要求每按一次开关产生一次中断,在屏幕上 显示一次“TPCA Interrupt!”,中断10次后 程序退出(Directly by hand to produce a single pulse as an interrupt request signal. Each time you press the switch requires an interrupt is generated, show a TPCA Interrupt! On the screen, interrupted 10 times after the program exits)
- 2014-12-14 10:06:38下载
- 积分：1
-
model_properties_callbacks
this is other mass-spring system show in gui
- 2010-12-26 06:17:01下载
- 积分：1
-
wireless-communication
说明： 使用matlab编程的m文件，对于了解使用m文件编程的方法有重要意义。(Programming using matlab m file, m file programming for understanding the methods used is important.)
- 2011-03-06 10:33:07下载
- 积分：1
-
OFDMBER
有关于OFDM在不同信噪比下的误比特率，大家可以看看啊(on OFDM different signal-to-noise ratio in the bit error rate, we can see ah)
- 2007-05-26 20:29:34下载
- 积分：1
-
Rolling_Schedule1
MATLAB编写的关于轧钢板型控制的研究(MATLAB written, about Rolling steel plate type control
)
- 2011-09-22 09:37:01下载
- 积分：1
-
Desktop
圆环阵的天线方向图 与基于SMI算法的线阵的自适应波束形成(Adaptive beamforming circular array antenna pattern SMI algorithm based linear array)
- 2014-02-18 18:21:36下载
- 积分：1
-
xitongbianshi
一些介绍系统参数辨识方法的论文，包括迭代梯度算法，最小二乘算法等。很好的资料。(Some paper describes the system parameter identification methods, including iterative gradient algorithm, least squares algorithm. Good information.)
- 2015-12-03 22:47:39下载
- 积分：1
-
bananaex
一个非高斯目标方法的例子，研究不同自适应方法(A non-Gaussian examples of the target method to study the different adaptive methods)
- 2012-04-18 09:51:25下载
- 积分：1
-
CUM4X
4阶高阶累积量的仿真程序，能使初学者掌握累积量的知识。(4-order cumulant of the simulation program, allows beginners to master the accumulation of knowledge.)
- 2011-10-12 19:02:39下载
- 积分：1
