-
MATLABck
MATLAB的一些参数设置的参考，方便对参数的设置，本人认为很好(MATLAB reference set some parameters to facilitate the setting of the parameters, I think a good)
- 2010-06-26 18:04:24下载
- 积分：1
-
RAYLEIGHFADINGMODELGENERATIONwithcodin
RAYLEIGH FADING MODEL GENERATION
- 2010-08-12 01:15:21下载
- 积分：1
-
Image_Processing_and_0Matlab
matlab 图像处理命令，对matlab初学者很有帮助。(matlab image processing orders, for matlab beginners helpful.)
- 2008-05-14 22:39:03下载
- 积分：1
-
fun
PSO算法，Quantum inspired PSO for the optimization of simultaneous recurrent neural networks as MIMO learning systems(PSO algorithm，Quantum inspired PSO for the optimization of simultaneous recurrent neural networks as MIMO learning systems)
- 2013-09-17 10:18:31下载
- 积分：1
-
SpectrumEstimationSimulation
说明： 关于谱估计的一些基本的程序.有自回归.esprit,music(Spectral estimation on some basic procedures, since the reunification, esprit, music)
- 2010-04-12 21:53:27下载
- 积分：1
-
matlabcs
三次样条插值的源程序，程序稍稍长了点
希望大家能用到(cubic spline interpolation of the source, procedures slight hope everyone can wait to)
- 2006-12-11 21:50:53下载
- 积分：1
-
xiashan
MATLAB 牛顿下山法的一个小程序，原理就不详细说了。因牛顿迭代法受初值选取的限制，为防止迭代发散，对迭代过程再附加一项要求:|f(x(k+1))|<|f(x(k))|,将牛顿法迭代的结果:x(k+1) =x(k)-f(x(k))/f (x(k))和前一近似值x(k)适当加权平均做为新的改进值:x(k+1)=u*x(k+1) +(1-u)*x(k),其中u(0<>
迭代时u取1开始，逐次减半计算，直至附加要求符合为止。实例计算中x(k)=x(0)不变，只更新u和x(k+1)，直至:|f(x(k+1))|<|f(x(k))|（即|f(x(1))|<|f(x(0))|)，然后更新下山因子为u=1,继续以牛顿法迭代。(MATLAB Newton-down a small program, the principle is not explained in detail. Newton iteration by the initial value of the selected limit, in order to prevent additional iterative divergence, the iterative process a request: | f (x (k+1)) | < | f (x (k)) | Newton iteration Results: x (k+1) ' = X (k)-f (x (k))/f' (x (k)) and a previous approximation x (k), appropriately weighted average as a new improved value: x (k+1 ) = u* x (k+1) ' + (1-u)* x (k), where u (0 < u> iteration take successive calculated at 50 until the additional requirements found so far. examples of calculation of X ( k) = x (0) unchanged profile u and x (k+1, hungry) until: | f (x (k+1)) | < | f (x (k)) | (i.e. | f (x (1)) | < | f (x (0)) |), then profile downhill factor for u = 1, to continue to Newton iteration.)
- 2013-05-15 08:52:09下载
- 积分：1
-
IEEE13MATLAB
IEEE13节点潮流计算程序，采用了MATLAB软件进行编程，利用前退回代法进行配电网的潮流计算(IEEE13 node flow calculation program, using MATLAB software programming, before use of return on behalf of the French distribution network power flow calculation)
- 2020-11-25 09:09:39下载
- 积分：1
-
sampling_square
this code is to sample the signal
- 2011-05-27 16:40:00下载
- 积分：1
-
CA
说明： 用MATLAB去写的关于元胞自动机的程度，比较容易上手，也比较简单易学。(Using MATLAB to write about the extent of cellular automata, and relatively easy to use, but also relatively easy to learn.)
- 2014-08-15 20:09:32下载
- 积分：1
