登录
首页 » VHDL » 用VHDL语言实现数字钟的设计

用VHDL语言实现数字钟的设计

于 2022-10-28 发布 文件大小:52.11 kB
0 134
下载积分: 2 下载次数: 1

代码说明:

用VHDL语言实现数字钟的设计,要求设计实现一个具有带预置数的数字钟,具有显示年月日时分秒的功能。用6个数码管显示时分秒,set按钮产生第一个脉冲时,显示切换年月日,第2个脉冲到来时可预置年份,第3个脉冲到来时可预置月份,依次第4、5、6、7个脉冲到来时分别可预置日期、时、分、秒,第 8个脉冲到来后预置结束,正常工作,显示的是时分秒。Up为高电平时,upclk有脉冲到达时,预置位加1.否则减1。

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • check_net_test
    用来检查FPGA通过PHY发送数据时是否有掉帧的现象(FPGA is used to check whether the PHY sends the data out of the frame with the phenomenon of)
    2011-11-18 10:28:02下载
    积分:1
  • 利用vhdl编写的双端口Ram程序,不带数据纠错处理
    利用vhdl编写的双端口Ram程序,不带数据纠错处理-VHDL prepared to use dual-port Ram procedures, do not deal with data error correction
    2023-03-13 05:20:04下载
    积分:1
  • HOWTO_-Get-Configuration-and-Location-Information
    this document used for how to get config and location information of PCI card
    2012-07-21 12:26:16下载
    积分:1
  • HDMI接口编解码传输模块ASIC设计_刘文杰
    说明:  ? 熟悉IIC协议总线协议,采用IIC总线对图像采集传感器寄存器进行配置,并转换为RGB565格式。 ? 利用异步FIFO完成从摄像头输出端到SDRAM 和SDRAM 到VGA 接口各跨时钟域信号的传输和处理。 ? 利用 SDRAM 接口模块的设计,实现了刷新、读写等操作;为提高SDRAM 的读写带宽,均采用突发连续读写数据方式;并采用乒乓操作实现 CMOS 摄像头与VGA的帧率匹配。 ? 利用双线性插值方法实现对图像640×480到1024×768的放大操作。 ? 完成VGA显示接口设计。(Familiar with IIC protocol bus protocol, IIC bus is used to configure the register of image acquisition sensor and convert it into RGB565 format. Asynchronous FIFO is used to transmit and process signals across clock domain from camera output to SDRAM and SDRAM to VGA interface. With the design of SDRAM interface module, refresh, read and write operations are realized. In order to improve the read and write bandwidth of SDRAM, burst continuous read and write data mode is adopted, and table tennis operation is used to achieve frame rate matching between CMOS camera and VGA. The bilinear interpolation method is used to enlarge the image from 640*480 to 1024*768. Complete the VGA display interface design.)
    2020-06-25 04:00:02下载
    积分:1
  • pj2-NO.6
    基于FPGA的电子密码锁设计-已在开发板上成功运行,通过老师检验。(FPGA based electronic password lock design- has been successfully developed on the development board, through the teacher inspection.)
    2017-05-26 11:54:44下载
    积分:1
  • liyuanlnx_IP_RAM
    FPGA——IP_RAM实验: 创建IPRAM核,单端口,10位地址线(256字节),8位数据线(每字节8byte),读写使能 input [9:0] address; input clock; input [7:0] data; input wren; //置1则写入 output [7:0] q; LNXmode:控制LEDC显示 1:mode1,从k1~k3输入data的低4位,ledb计时,从0~f,计时跳变沿读取k1~k3的值,存入RAM 8个数之后,从RAM输出数据,用leda显示,同样每秒变化一次(The experiment of FPGA-IP_RAM: Create IPRAM core, single port, 10 bit address line (256 bytes), 8 bit data line (8 byte per byte), read and write enablement)
    2020-06-22 04:20:02下载
    积分:1
  • 一种新的FIFO实现方法,verilog描述,通过modelsim 6.0 仿真,Quartue综合...
    一种新的FIFO实现方法,verilog描述,通过modelsim 6.0 仿真,Quartue综合-FIFO realize a new method, verilog description, modelsim 6.0 through simulation, Quartue integrated
    2023-01-18 15:40:03下载
    积分:1
  • verilog编写的计算百分比模块
    verilog编写的计算百分比模块-Verilog prepared by calculating the percentage module
    2022-01-31 18:38:18下载
    积分:1
  • 用VHDL实现的DDS逻辑,大家可以参考下
    用VHDL实现的DDS逻辑,大家可以参考下-DDS achieved using VHDL logic, we can refer to the following
    2022-08-10 09:43:58下载
    积分:1
  • AD7608
    8通道同步AD芯片7608的FPGA控制程序(FPGA control program of ad7608(8 channel synchronous AD chip))
    2021-03-13 12:09:24下载
    积分:1
  • 696518资源总数
  • 106164会员总数
  • 18今日下载