-
matlab-dsp-of-chengyayong
陈亚勇的信号处理在MATLAB中的应用，好书(Of Chen Yayong the signal processing in MATLAB, a good book)
- 2012-10-04 22:12:54下载
- 积分：1
-
mimomomxing
MIMO（多输入多输出）信道模型建matlab环境，瑞利信道下mimo无线通信系统的仿真模及仿真(MIMO (Multiple Input Multiple Output) channel model matlab built environment, Rayleigh fading MIMO wireless communication system simulation mode and simulation)
- 2007-12-17 08:51:56下载
- 积分：1
-
stop-and-wait-arq
Stop-and-wait ARQ is a method used in telecommunications to send information between two connected devices. It ensures that information is not lost due to dropped packets and that packets are received in the correct order. It is the simplest kind of automatic repeat-request (ARQ) method. A stop-and-wait ARQ sender sends one frame at a time it is a special case of the general sliding window protocol with both transmit and receive window sizes equal to 1. After sending each frame, the sender doesn t send any further frames until it receives an acknowledgement (ACK) signal. After receiving a good frame, the receiver sends an ACK. If the ACK does not reach the sender before a certain time, known as the timeout, the sender sends the same frame again.
- 2011-08-03 16:53:31下载
- 积分：1
-
TheCalculationandAnalysis
利用二维有限差分法对单脊波导TM模进行计算。通过调整网格数目观察计算结果的精度，可以设定出最优的网格数目，然后改变波导中脊的尺寸，观察最低两个TM模对应的截止频率的变化规律，最后给出对应的横截面电场、磁场分布图(The two-dimensional finite difference method to calculate the single-ridge waveguide TM mode. The optimal number of grid can be set by the accuracy of the adjustment of the calculation result of the grid number observed, and then change the size of the waveguide ridge observed the lowest two corresponding to the TM mode of the cutoff frequency of the variation, and finally to give the corresponding cross cross-section of the electric field, magnetic field maps)
- 2013-03-18 12:22:11下载
- 积分：1
-
kalman
说明： 拥有matlab用户界面的卡尔曼滤波程序-MATLAB源代码(Matlab user interface with Kalman filter-MATLAB source code program)
- 2011-04-11 20:41:51下载
- 积分：1
-
unitpower
说明： 设置电容型脉冲电源的电容、电感、回路和负载的电感电阻等参数，可以计算出脉冲电源的输出电流。(The output current of the pulse power supply can be calculated by setting parameters such as capacitance, inductance, loop and load inductance resistance of the pulse power supply.)
- 2019-03-26 15:57:53下载
- 积分：1
-
MATLAB-GUI-II
matlabgui matlab 绘图相关教程书内附源码 (matlabgui matlab drawing related code)
- 2013-03-19 11:22:08下载
- 积分：1
-
xiangkongzhen
matlab相控阵波束形成和检测代码，可帮助理解相控阵波束形成原理(matlab phased array beamforming and detection codes, can aid in understanding the principles of phased array beamforming)
- 2017-03-27 07:20:56下载
- 积分：1
-
ED_GA
Economic Dispatch for generating power system with Genetic Algorithm
- 2013-03-13 00:38:34下载
- 积分：1
-
Calculator
Project of calculator program as an example for students for studying of C++ Builder programming environment.
- 2014-11-24 15:46:16下载
- 积分：1
