-
MATLAB
matlab工具，适合初学者使用~~~~~~~~~~~~~~~~~~~~~~(no)
- 2010-05-22 01:42:23下载
- 积分：1
-
多自由度地震
简单的多自由度地震反应EI_Centro波，采用威尔逊逐步积分法(A simple multi degree of freedom seismic response EI_Centro wave using Wilson stepwise integral method)
- 2020-08-16 16:48:23下载
- 积分：1
-
基于神经—模糊网络的光伏阵列MPPT控制研究
基于神经—模糊网络的光伏阵列MPPT控制研究(Research on pv array MPPT control based on neural - fuzzy network)
- 2018-07-18 22:24:10下载
- 积分：1
-
logistic
给定初始值，产生费根鲍姆迭代轨迹，logistics映射，周期点等程序(Given initial value, resulting in iterative trajectory Feigenbaum, logistics map, periodic points and other procedures)
- 2010-09-27 16:48:42下载
- 积分：1
-
Anfis
Fuzzy control Design using ANFIS for a power system with svc
- 2009-06-03 16:46:06下载
- 积分：1
-
modified_sinr_cal
The signal received by a user over the forward link in such a high data rate system contains interference from the neighboring base stations. we note that the strength of this interference is a function of the network load in the neighboring cells. we obtain an expression for the received SINR (Signal to Interference and Noise Ratio) as a function of the traffic load in the interfering cells. Using this result, we propose an improvement to the SINR estimation scheme that is implemented in the current cellular data network. The proposed scheme provides a more accurate estimate of the user SINR by taking better account of the contribution of inter-cell interference. It builds on top of the current SINR measurement scheme by using a combination of pilot measurement and traffic load measurement
- 2011-10-10 17:05:17下载
- 积分：1
-
MATLAB-Code-to-observe-the-variations-in-q-axis-a
MATLAB Code to observe the variations in q-axis and d-axis stator currents with change in stator voltage for a three phase induction motor
- 2014-12-04 13:31:27下载
- 积分：1
-
DFIG_simplified_crowbar
说明： 此模型中的撬棍不是使用IGBT或理想开关制造的。
通过
改变转子侧变流器的参考电压来模拟撬棍电路的切入和切出 。
该模型是使用MATLAB R2010a创建的。
控制策略是最常见的去耦
算法和MPPT(The crowbar in this model is not manufactured using IGBTs or ideal switches.
by
The reference voltage of the rotor-side converter is changed to simulate the cut-in and cut-out of the crowbar circuit.
The model was created using MATLAB R2010a.
Control strategy is the most common decoupling
Algorithm and MPPT)
- 2019-10-23 09:35:26下载
- 积分：1
-
GA
说明： 用matlab语言编写的遗传算法程序，可以求最优值，可以参考一下(Languages with matlab genetic algorithm procedure, you can seek the optimal value, you can refer to)
- 2008-12-10 15:34:49下载
- 积分：1
-
master_matlab
大家看看吧，很好的Matlab学习资料(Let everyone take a look at, very good learning materials Matlab)
- 2008-04-20 10:22:07下载
- 积分：1
