登录
首页 » matlab » powerflow

powerflow

于 2008-03-27 发布 文件大小:16KB
0 87
下载积分: 1 下载次数: 110

代码说明:

  matlab编写的潮流计算程序,对于c语言头痛者的良好选择(matlab prepared flow calculation procedures, for c language are a good selection headache)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • OFDMcode
    采用Matlab仿真的OFDM链路代码,可以运行并生成性能曲线(maltab code for OFDM communication system,and performance is good)
    2012-05-06 10:40:58下载
    积分:1
  • kalman
    卡尔曼滤波器例子,跟踪目标,可以用去除噪声(Kalman filter example, target tracking Can be used to remove noise)
    2012-05-06 16:22:32下载
    积分:1
  • Bee-algorithm5
    Bee algorithmBee algorithmBee algorithm(1)信号处理、(2)人工智能与模式识别、(3)神经网络、(4)图像处理、(5)数据挖掘、(Bee algorithm3)
    2013-09-10 10:21:12下载
    积分:1
  • pso
    粒子群算法参数辨识,用于调速系统参数辨识的适应度函数选择(Particle swarm optimization)
    2021-04-27 15:38:44下载
    积分:1
  • Kinematic-Hardening-Plasticity
    A UMAT Coding for Kinematic Hardening Plasticity.
    2013-10-18 19:18:14下载
    积分:1
  • DCT-Based--Watermarking-Scheme
    a self- embedding block wise fragile watermarking scheme with tamper detection and content recovery capability. The proposed scheme embeds the shuffled extensive ten bit Recovery data and two bit Authentication data of the image block into the least significant bits (LSB) of its corresponding mapping block.The integrity of a test block is decided by comparing 2×2 non overlapping block of the test block with its corresponding mapping block. Experimental results show that the suggested scheme outperforms conventional self recovery fragile watermarking algorithms in alteration detection as well as in tamper recovery of the image.
    2014-02-15 21:17:17下载
    积分:1
  • FLYFOT_M160
    本手册描述了 FLYFOT 模块的硬件接口特性、应用开发参考设计。 通过阅读本手册,用户可以开发自己的应用系统。本手册适用于 M160 模块的以下软硬件版本: 硬件:P1,软件:M160.(This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without prior written agreement.)
    2010-11-05 10:42:14下载
    积分:1
  • ech33
    fdtd 1d photonic crystal Band diagram
    2012-10-20 23:10:12下载
    积分:1
  • cooperative-paper-with-matlab-code
    An ad-hoc network with a sender, a destination and a third station act- ing as a relay is analysed. The channels are modelled containing thermal noise, Rayleigh fading and path loss. Di® erent combining methods and di- versity protocols are compared. The amplify and forward protocol shows a better performance than the decode and forward protocol, unless an error correcting code is simulated. To combine the incoming signals the chan- nel quality should be estimated as well as possible. Information about the average quality shows nice bene¯ ts, and a rough approximation about the variation of the channel quality increases the performance even more. What- ever combination of diversity protocol and combining method is used second level diversity is observed. The relative distances between the relay and the stations has a large e® ect on the performance.
    2015-02-28 15:30:52下载
    积分:1
  • solver
    解集机制之solver 详情见源代码。辛苦写的(The mechanism of the solver solution set details, see the source code. Hard to write)
    2013-01-04 19:50:33下载
    积分:1
  • 696524资源总数
  • 103939会员总数
  • 12今日下载