-
yuyinxinhaochuli
语音处理是信号与信息处理的重要内容之一，通过本课程设计，使学生理解数字信号处
理的有关理论和方法在语音处理中的具体应用。课程设计的目的归纳如下：
1、掌握语音信号的特点；
2、掌握语音处理的基本理论和方法；
3、掌握基于Matlab编程实现语音的获取、显示、频谱分析、短时能量、短时自相关以及倒
谱复倒谱的分析方法；
4、掌握语音基音频率及共振峰频率的检测方法。(Signal and speech processing is an important part of information processing, through the curriculum design, so that students understand the digital signal
The theory and methods of management in voice processing in the specific application. Curriculum is designed to be summarized as follows:
A master speech signal characteristics
2, master the basic theory and speech processing methods
3, master Matlab programming based voice access, display, spectrum analysis, short-time energy, short-term autocorrelation and inverted
Spectral analysis of the complex cepstrum method
4, master voice pitch frequency and formant frequency detection method.
)
- 2013-09-12 19:13:45下载
- 积分：1
-
lab3-28069-timer0-led
TMS320F28069例程，LED运算例程，可以直接试用在ccs4中建立(TMS320F28069 examples of led)
- 2013-05-03 16:21:48下载
- 积分：1
-
cxcore
在进行图像处理相关DSP编程时，需要移植opencv到CCS平台。作者提供了将Opencv（1.0版本）的cxcore函数库移植到CCS的静态链接库cxcore.lib，以及其生成工程，该例程经作者编译听通过（ccs3.3版本）。由于工程中产生的obj文件和lib文件太大，在工程中已经将其删除，读者在使用时，只需要对工程重新编译即可。最后将生成的cxcore.lib添加到CCS的工程中即可（不要忘了添加相应的头文件），由于cxcore.lib一般和cv.lib配套使用，读者在下载cxcore.lib时也一并将cv.lib下载。作者也提供了将cv.lib与cxcore.lib添加到工程中的实验例程，并且该例程编译通过。也希望读者在该论坛找到该例程将其一并下载，配合使用。(During image processing DSP programming related, it is necessary to transplant opencv CCS platform. The authors provide the Opencv (1.0 version) of cxcore CCS library ported to the static link library cxcore.lib, as well as its generation project, the routine is compiled by the author to listen through (ccs3.3 version). As the project has generated obj files and lib file is too large, the project has been to remove it, the reader is in use, only need to recompile the project. Finally, the resulting cxcore.lib added to the CCS project can (do not forget to add the appropriate header files), as cxcore.lib general and cv.lib supporting the use of the reader and download cxcore.lib when a cv . lib download. The author also provides a cv.lib cxcore.lib added to the project with the experimental routine, and the routine compile. I hope readers find in this forum and download one of the routine, with the use.)
- 2013-06-22 14:51:32下载
- 积分：1
-
uart-simple-1driver
DSP串口驱动程序，初学者可以作为DSP串口驱动程序的入门代码使用(DSP serial port driver, beginners as DSP serial port driver entry code uses)
- 2020-11-16 11:49:40下载
- 积分：1
-
DSP
本例子是边缘检测算法的DSP实现程序，采用的算法是canny算子检测。(This example is the edge detection algorithm on DSP program, the algorithm uses a canny operator testing.)
- 2020-11-19 15:09:38下载
- 积分：1
-
cmd
DSP CMD文件 连接器命令文件，CMD文件编写，CMD文件原理，关于DSP中CMD文件的解释，包含3个文件，对cmd介绍相当详细(DSP CMD file the linker command file, CMD document preparation, CMD file principle, on the interpretation of DSP in the CMD file that contains 3 files, very detailed description of cmd)
- 2011-02-15 12:01:13下载
- 积分：1
-
基于TMS320F28335的MODBUS-RTU从站程序
说明： 基于TMS320F28335的MODBUS-RTU从站程序(MODBUS-RTU slave program based on TMS320F28335)
- 2021-04-21 14:48:49下载
- 积分：1
-
lab0309-Pwm
这个程序设置了EV定时器（Time1、Time2、Time3和Time4）。
产生T1PWM、T2PWM、T3PWM、T4PWM和PWM1-12波形。
然后用户可以使用范围来观察波形。(This program sets up the EV timers (TIMER1, TIMER2, TIMER3 and TIMER4) to generate T1PWM, T2PWM, T3PWM, T4PWM and PWM1-12 waveforms. The user can then observe the waveforms using an scope.)
- 2018-06-27 08:52:43下载
- 积分：1
-
ROOM-MUSIC
空间平滑MUSIC算法的MATLAB程序，针对与阵列信号的处理，可用于近场声全息技术中。(good,very good.)
- 2013-05-15 16:05:37下载
- 积分：1
-
MPPT
说明： 对Boost升压电路进行设计与性能优化；
（2）完成DC变换器环节实现光伏最大功率跟踪硬件电路设计，分析其实现最大功率跟踪控制的理论依；
（3）研究实现基于DSP光伏最大功率跟踪的算法，及其控制流程图；
（4）选择适合的最大功率跟踪算法，编写软件程序实现光伏电池的最大功率输出，尽可能提高光伏发电系统的效率。(In this paper, I will mainly research the maximum power tracking technology of the PV, design and improve the Boost circuit (Boost cut broken circuit). First, I measuring the electrical characteristics of photovoltaic cells , and get the output characteristics of photovoltaic cells; then based on Boost circuit of implementations, analysis the works of Photovoltaic maximum power tracking. Then, based an the DSP microcontroller TMS320F2812 , I use the method of perturbation and observation ,to do the programming based on C language.)
- 2019-01-18 19:52:15下载
- 积分：1
