-
chapter5_1
倒谱的matlab实现,先用cool edit 软件录制歌曲(the relization of cepstrum of Matlab)
- 2011-05-09 12:44:39下载
- 积分：1
-
main
基于信息融合的粒子滤波跟踪技术研究的MATLAB源码(Particle filter tracking based on information fusion technology research)
- 2012-04-29 16:20:39下载
- 积分：1
-
Off_line_LMS
off line FX-LMS algorithm to reduce noise from primary path
- 2013-10-16 19:47:02下载
- 积分：1
-
nonnegativeICAexample
非负独立分量盲源信号的分离方法是一种很简单的盲源分离方法(Non-negative independent component blind source separation method is a very simple blind source separation methods)
- 2013-10-30 11:05:47下载
- 积分：1
-
Channel_Capacity
《空时无线通信导论》，第四章的所有图片的matlab的重现程序，和仿真结果。仿真程序包括MIMO信道容量、发射端不知晓信道信息时信道容量等程序。(" Introduction to space-time wireless communications," Chapter IV reproduce all the pictures of matlab procedures, and simulation results. The simulation program, including MIMO channel capacity, the transmitter does not know when the channel information channel capacity and other procedures.)
- 2021-03-13 10:59:24下载
- 积分：1
-
relay
两种中继增益选择蒙特卡洛仿真的比较,基于matlab语言(Two kinds of relay gain selection Monte Carlo simulation comparison, based on matlab language)
- 2020-09-04 14:08:06下载
- 积分：1
-
MSE
Comparison of the performances of the LS and the MMSE channel estimators
for a 64 sub carrier OFDM system based on the parameter of Mean square error
- 2007-11-08 10:25:56下载
- 积分：1
-
5
fault at stator in induction motor
- 2010-03-13 16:15:09下载
- 积分：1
-
OFDM
OFDM,实际上OFDM是MCM Multi-CarrierModulation，多载波调制的一种。其主要思想是：将信道分成若干正交子信道，将高速数据信号转换成并行的低速子数据流，调制到在每个子信道上进行传输。正交信号可以通过在接收端采用相关技术来分开，这样可以减少子信道之间的相互干扰 ICI 。每个子信道上的信号带宽小于信道的相关带宽，因此每个子信道上的可以看成平坦性衰落，从而可以消除符号间干扰。而且由于每个子信道的带宽仅仅是原信道带宽的一小部分，信道均衡变得相对容易。在向B3G/4G演进的过程中，OFDM是关键的技术之一，可以结合分集，时空编码，干扰和信道间干扰抑制以及智能天线技术，最大限度的提高了系统性能。(OFDM)
- 2010-05-21 14:56:54下载
- 积分：1
-
MATLAB
简单潮流计算的小程序，相关的原始数据数据数据输入格式如下： B1是支路参数矩阵，第一列和第二列是节点编号。节点编号由小到大编写 对于含有变压器的支路，第一列为低压侧节点编号，第二列为高压侧节点 编号，将变压器的串联阻抗置于低压侧处理。 第三列为支路的串列阻抗参数。 第四列为支路的对地导纳参数。 第五烈为含变压器支路的变压器的变比 ( Simple little program flow calculation, the raw data of the data related to data entry format is as follows: B1 is the slip parameter matrix, the first column and second column is the node number. Node number from small to big with the transformer for the preparation of slip, the first as the low pressure side of the node number, the second as a high-pressure side of the node number, the series impedance of the transformer low voltage side of the deal placed. As the third branch of the serial impedance parameters. Fourth as a slip of the ground admittance parameters. Strong as with the fifth branch of the transformer transformer turns ratio )
- 2010-05-23 18:40:11下载
- 积分：1
