-
Embedded_first_steps
This book is a good for the beginner in embedded system
- 2012-01-08 23:57:48下载
- 积分：1
-
铝型材锯切控制程序
说明： PLC control program, automatic cutting production line for aluminium profile
- 2019-05-27 11:23:51下载
- 积分：1
-
DG-access-technical-requirements
本规定适用于国家电网公司经营区域内以同步电机、感应电机、变流器等形式接入35kV及以下电压等级电网的分布式电源。(This regulation applies to the national grid company operating in the region access to the synchronous motor, induction motor, inverter and other forms of 35kV and below voltage distributed power grid.)
- 2021-03-06 17:29:30下载
- 积分：1
-
DIANSAI
有关参加全国大学生电子设计竞赛培训的一些情况介绍(Some related to take part in the national undergraduate electronic design contest training was introduced
)
- 2013-08-11 11:49:44下载
- 积分：1
-
HVAC PART03- By Eng. Ramy Ghoraba
HVAC PART03- By Eng. Ramy Ghoraba
- 2020-06-25 19:40:02下载
- 积分：1
-
3
说明： Ph-metr do akwarium - kontrola CO2
- 2011-11-04 05:11:39下载
- 积分：1
-
111
用GAL16V8设计可变长度序列信号发生器，在掌握伪随机序列性质的基础上，设计给定长度的伪随机序列信号发生器，也即设计给定n后（n为移位寄存器的级数）最长线性反馈移位寄存器序列。并在给定n产生的最长序列的基础上，截短出课题给出的序列长度，并用FM软件对可编程器件GAL16V8进行编程，以实现长度不同的序列信号发生器。(GAL16V8 design variable-length sequence signal generator based on the master pseudo-random sequence nature, the design of a given length pseudo-random sequence
Signal generator, designed for the series) up to linear feedback shift register sequences given n (n is the shift register. And given n
Sequence length given by the subject on the basis of the longest sequence, truncated, and FM software for programming the programmable device GAL16V8, in order to achieve
Different length of the sequence signal generator.)
- 2012-03-28 08:38:15下载
- 积分：1
-
SP200S_Programmer_DIY
SP200S的的51烧录器资料和程序，还有原理图(51 of SP200S burner information and procedures, as well as schematic)
- 2020-12-16 16:09:14下载
- 积分：1
-
ThePulse-detectingInstrumentBasedonUSBInterface
基于USB接口的脉搏检测仪本文设计该检测仪由硬件和软件两部分组成硬件电路包括数采集电路放大滤波电路控制电路及电源电路(ThePulsedetectingInstrumentBasedonUSBInterface)
- 2009-02-22 11:50:56下载
- 积分：1
-
k-19
Digital bird kit circuit design
- 2011-10-11 13:30:29下载
- 积分：1
